For 2000W Hybrid Controller
Product introduction:
This
kind of wind solar hybrid street light controller is a special design
for small off-grid devices where wind generators and solar panels charge
batteries safely and efficiently.
Functions:
** Wind generator MPPT boost charging function.
** Wind PWM dump load, external dump load resistor, intelligent solar charge separation.
** Dual power supply function: battery + solar power supply.
** LCD displays parameters such as voltage and current of wind, sun and load. Some parameters can be set by the user.
** DC output with 3 output modes.
** The inner circuit board of the controller is sprayed with protective paint to prevent dust, moisture and static electricity.
Features:
** Wind & Solar MPPT charging method, ensure the power get max input into the battery and high charging efficiency.
** Can be used for wind turbines with high compatibility.
** Independent Boost Circuit: The charging efficiency of the low-power vertical wind generator has been solved.
** 12V/24V (12V/24V/48V) system auto-detect function.
** Mini size, easy to install.
** LCD display with visible and intuitive parameters.
** Rated wind power: 100-1000W
** PV Rated Power: 100-2000W
Package list:
1 * Wind&Solar hybrid charge controller with dumpload
Thank
you for purchasing our products. This manual is intended for people who
need to install and operate the controller. Read this manual before
doing any work on the controller and keep it in a safe place. The
content of this manual is regularly updated or revised as necessary.
However, deviations cannot be ruled out. Please refer to the actual
product(s).
General Safety Information:
** Before you
receive the product, please check it carefully. Make sure the product
has not been damaged in transit. If it is damaged, contact the carrier
or our company immediately.
** All installation and electrical work may only be carried out by qualified personnel.
** Do not disassemble or attempt to repair the controller without professional guidance.
** Do not use the controller without batteries.
** Do not disconnect the controller and batteries when the controller works normally.
** Keep children away from the controls.
** Do not allow water to get into the controller.
**
Ensure power connections are tight to avoid excessive heating from a
loose connection. Make sure the cables are appropriate for the system.
For 800W Wind Turbine:
Specifications:
Type: Pure Sine Wave Inverter
Output Voltage Waveform: Pure sine wave
Power: 2000W Peak / 800W Continuous
Output voltage: 220V
Input voltage: 12V/24V/48V
Output frequency: 50Hz
Socket: Universal
In the Box:
1 x Pure Sine Wave Inverter
1 x User manual
Peak power 2000W
Continuous power 800W
Weight: 2 kg
Features:
- Aluminum-magnesium alloy shell, light weight, good thermal conductivity.
- Digital Battery Volts Display
- Pure sine wave, intelligent filter, does not interfere with electrical appliances, protects electrical appliances. With high conversion efficiency (up to 95%), the low power consumption of the product can greatly extend battery life.
- You can use electrical equipment, including TV / LED lights / LCD displays, especially inductive load appliances such as refrigerators, freezers, induction cookers.
- Pure sine wave inverter.
- 8-bit intelligent protection: overload protection, high voltage protection, low voltage protection, overheating protection, reverse connection protection, short circuit protection, overcurrent protection, surge protection, intelligent chip control.
- Intelligent temperature control fan means the inverter is quiet. When the temperature is ≤45 ℃, the fan is not spinning; when the temperature is ≥45 ℃, the fan starts working.
- Buzzer reminder. Once any protection of the inverter is triggered, the inverter will immediately disconnect, the inverter enters the protection mode, with a buzzer reminder.
