These stands are specific to the Tamiya Lunch Box and Midnight Pumpkin. They support the truck at the gear box and under the front suspension arms and lift the truck about 3/4 inch off the ground.
Sold as a set (front & rear). The quantity listed are ready to ship. I can always make more. Just message me and I'll increase the quantity available.
I created these stands to help solve the issue of tire damage when models are stored or on display for long periods of time. These simple stands are laser cut from 1/4” plywood, easy to assemble, and can by left as is or finished in a variety of ways.
Assembly
Paint/Finishing
- It’s best to assemble the stands before finishing to avoid any fitment issues
- Almost any type of finish can be used but... a stain blocking primer is required to cover the “burned” edges or they may bleed through paint
If the pieces won’t fit together (This shouldn’t happen, but I suppose it’s possible)
- A little sanding will always do the trick
- Try inserting the piece through the other side (noting directional orientation if required). The hole will be slightly larger on the side where the laser penetrated first
- You can try tapping the pieces together using a hammer and a flat surface but do not apply heavy pressure outside of the tabbed areas.
NOTE: Any aftermarket or tire modification to the model may affect fitment. (Obviously the truck is not included.)