[Fitment]
 for Mitsubishi Triton ML MN 2006-2014

Note:
●if no mudflaps, suit for your vehicle; Or, your mudflaps must be the ones shown in our picture, then suits
●Suit for car model without a bull bar. ( Fender flares need to be trimmed to to suit your vehicle with a bullbar

[Description]
--These wrinkle fender flares are premium products with pre-applied sticky tape and pre-drilled holes for easy and quick installation.
--The exact and precise product fits your vehicle's fender lines perfectly.
--The fender flares measurements are approximately  6 inches(155mm) for the width.
--Includes mounting hardwares

[Specification]
--Tyre Coverage: Widen by 35mm
--Color: Paintable Matte Black Finish 
--Material: Ultra-flexible ABS plastic
--Style: Riveted-bolt wrinkle style (These bolts are just for looks, no need to drill holes on vehicle)
--Package: Front & Rear set
--Feature: UV Protection, No Chalking, Cracking, or Warping; Extra Side Protection Against Debris; 
Note: Professional installation is highly recommended



[Package]
Full Set Fender Flares with hardwares (2 for front and 2 for rear)

[Instructions] Pls pre-heat adhesive tape before installation to get better fitment
1. Clean the installed area and make sure it is dry for a better installtion.
2. Install these cosmetic bolts onto flare pieces
3. Test and fit flare pieces onto your vehicle, peel away 1 inch of adhesive backing tape from each corner; once align, peel away the rest backing stip tape while applying pressure to flares pieces to make a tight fitment.
4. Use fix fasteners to set flare pieces into place. 
5. Do visual check on all areas. Don't wash your vehicle within 24hrs


Note:
--Does not come with installation manual.
--Pre-drilled holes may not align with your factory holes, minor drilling might be required on our fender flares to accurately line up (Don't need drill a hole on vehicle)
--Oversized items may cost extra freight fee in some regions, due to the logisticians insufficient carrier capacity recently.