Description
End-Fed Antenna HAM Four-Band Shortwave Antenna SDR Shortwave Receiving Antenna K4EDF
Description:
K4EDF is a four-band end-fed antenna.
The advantage is that it has a very wide working bandwidth compared with other types of antennas (refer to the measured SWR graph). Normally, the natural resonance is more than 1 meter above the ground.
On the frequency. And the height change does not affect the resonance point very much, so it can be used without trimming, and the 40-meter band operates at half wavelength, the 20-meter band operates at one wavelength, and the 15-meter band at one-half wavelength. Working, the 10 meter band operates at two wavelengths, the four waves are naturally resonant and the gain radiation efficiency is still very high, very suitable for a novice entry antenna (without trimming).
The disadvantage is that the matching method is to use a high-ratio conversion balun. The heat loss is relatively large due to the ratio of the turns ratio and the magnetic flux density and the upper limit of the magnetic flux operating frequency. Therefore, this antenna is very suitable for beginners (not suitable for long-term continuous launching). , suitable for interval transmission and reception), amateur band SDR reception. There is no problem in receiving broadcasts, and it is also suitable for broadcasters.
The custom magnetic ring currently used reduces the loss to the lowest limit, and the actual test is safely transmitted with 100W SSB for 30 minutes! (Normal test balun only takes 10 minutes to continuously emit normal temperature and is qualified), we are all passed the super-strength violence test!
2.5 square MM multi-strand pure copper wire upgraded vibrator increases working bandwidth and tensile strength. Low standing wave with wider operating bandwidth.
It is designed with M connector. Large magnetic ring (loss is minimized) plus PCB are used to fix balun.
Parameters:
- Four-Band: 7MHZ 14MHZ 21MHZ 28MHZ
- Standing Wave: Less than 1
- Withstand Power: 100WPEP
- Balun Insertion Loss: about 1.5DB
- Vibrator with 2.5 square MM pure copper multi-strand line (UV-resistant for all-weather outdoor long-term erection)
- Length of Antenna: about 20 meters
- Installation Way: Horizontal Installation, Incline Installation and Vertical Installation
Package Included:
- 1 x End Fed Antenna
Note: Feeder is not included in the package. Please purchase separately. Thank you!
Description:
K4EDF is a four-band end-fed antenna.
The advantage is that it has a very wide working bandwidth compared with other types of antennas (refer to the measured SWR graph). Normally, the natural resonance is more than 1 meter above the ground.
On the frequency. And the height change does not affect the resonance point very much, so it can be used without trimming, and the 40-meter band operates at half wavelength, the 20-meter band operates at one wavelength, and the 15-meter band at one-half wavelength. Working, the 10 meter band operates at two wavelengths, the four waves are naturally resonant and the gain radiation efficiency is still very high, very suitable for a novice entry antenna (without trimming).
The disadvantage is that the matching method is to use a high-ratio conversion balun. The heat loss is relatively large due to the ratio of the turns ratio and the magnetic flux density and the upper limit of the magnetic flux operating frequency. Therefore, this antenna is very suitable for beginners (not suitable for long-term continuous launching). , suitable for interval transmission and reception), amateur band SDR reception. There is no problem in receiving broadcasts, and it is also suitable for broadcasters.
The custom magnetic ring currently used reduces the loss to the lowest limit, and the actual test is safely transmitted with 100W SSB for 30 minutes! (Normal test balun only takes 10 minutes to continuously emit normal temperature and is qualified), we are all passed the super-strength violence test!
2.5 square MM multi-strand pure copper wire upgraded vibrator increases working bandwidth and tensile strength. Low standing wave with wider operating bandwidth.
It is designed with M connector. Large magnetic ring (loss is minimized) plus PCB are used to fix balun.
Parameters:
- Four-Band: 7MHZ 14MHZ 21MHZ 28MHZ
- Standing Wave: Less than 1
- Withstand Power: 100WPEP
- Balun Insertion Loss: about 1.5DB
- Vibrator with 2.5 square MM pure copper multi-strand line (UV-resistant for all-weather outdoor long-term erection)
- Length of Antenna: about 20 meters
- Installation Way: Horizontal Installation, Incline Installation and Vertical Installation
Package Included:
- 1 x End Fed Antenna
Note: Feeder is not included in the package. Please purchase separately. Thank you!
Payment Terms
1. We accept PayPal,Payoneer,Visa Card,Google pay,Credit card etc.
2. We ship to your eBay or Paypal address. Please make sure your eBay and Paypal address is correct before you pay.
2. We ship to your eBay or Paypal address. Please make sure your eBay and Paypal address is correct before you pay.
Shipping Terms
1. We will process the order within the handling time ,if you have any questions, please contact us via eBay message or email.
2. For remote regions of DHL/FedEx..., extra shipping costs might be charged. Usually it costs about 30USD-50USD. We will contact you if shipping company informed us your address belongs to remote area. Thanks for your understanding.
2. For remote regions of DHL/FedEx..., extra shipping costs might be charged. Usually it costs about 30USD-50USD. We will contact you if shipping company informed us your address belongs to remote area. Thanks for your understanding.
Return Terms
If you receive the item that not satisfied or defective, please do not open case and kindly notify us within 30 days. We will guide you the returning process for replacement or refund.
Custom Duties & Taxes
1. It is buyer's responsibility to cover the import duties, taxes.We do not charge any taxes and fees, and the possible taxes and fees will be collected by the platform or by third parties such as customs and carriers.
2. Please check with your country's customs office and inform us what/how much should declare before shipping.
2. Please check with your country's customs office and inform us what/how much should declare before shipping.
Feedback
1. Please kindly leave us a positive feedback and 5 star DSR if you satisfied with our product and service. Please feel free to contact us firstly if you have any problem with your order, we are responsible and credible seller and will solve the issue it for you asap.
2. If you are dissatisfied for any reason, please don't be quick to leave us neutral or negative feedback. We work hard to make sure EVERY CUSTOMER 100% SATISFIED and resolve any problem for you and always leave positive feedback to all our customers.
2. If you are dissatisfied for any reason, please don't be quick to leave us neutral or negative feedback. We work hard to make sure EVERY CUSTOMER 100% SATISFIED and resolve any problem for you and always leave positive feedback to all our customers.