Adopt USB3.1 GEN2(10Gbps) protocol, it provides an convenient and efficient solution for your work demands.
Important
|
|
|
---|---|---|
Step1Insert the target disk and the source disk into the slot respectively. Be sure not to misplace. Please note: The target drive must be equal to or larger than the source drive. |
Step 2Connect the power adapter. Then turn on the device. Do not connect to the computer via data cable. |
Step 3Press and hold the "start" button, and power on the device while holding the start button, keep holding the start button until you see all four lights are on and then off, then 25% of the progress light is flashing. You can release the start button. Note: All the lights will turn on when clone is completed. |
* | Target disk capacity has to be LARGER than original disk capacity. Please note: All data in the target disk will be overwritten when copying. |
* | Do not connect to the computer while Cloning. |
* | SSD condition: If there is a bad sector in the SSD, copying may stop. Scan the SSD once before copying to make sure there are no bad sectors. |
* | The target disk will enter the offline mode after clone is finished, so the target disk cannot be recognized when you connect the device to your computer. Please manually select online on the disk management/disk utility. |
* | The indicator light shows the clone progress (25% -50% -75% -100%), and all the lights will turn on when clone is completed. |
|
|
|
---|---|---|
Two removable fastenerEasy Assembly for different sizes of SSDs. Secure your SSD with fastener. No need for screw and screwdriver. |
Slide designThe enclosure is fixed by a screw. Loosen the screw and slide it back slightly to open the upper cover. |
Four non-slip padsEffectively prevent the device from sliding at will. Ensure the safety and stability of the operation process. |
Frequently Asked Questions
A: The target drive must be equal to or larger than the source drive. So cloning 256gb(source disk) to 1tb(target disk) is ok.
A: The four indicator lights will always be on.
A: No. It can only support NVMe to NVMe. It can only support NVMe PCIe M.2 SSD M-Key 2230 2242 2260 2280.
A: The target disk will enter the offline mode after clone is finished, so the target disk cannot be recognized when you connect the device to your computer. Please manually select online on the disk management/disk utility.
A: Yes, you can.
A: It can clone to a larger drive. But the clone will not change or resize the partition. Cloning will not change anything.
A: Both are ok. It is a m.2 cloner, but you can also use it as external ssd enclosure to access data.