Fuel Gauge Interface Module Ohm Range Converter For Update Gas Tank/ New Gauge
Product Description:
Material: plastic
Product size (length * width * height): 35* 20*16mm
Packing size: 12*9.5*2CM
Gross weight: 0.1KG
Net weight: 0.05kg
Important instructions:
① Install the module in a clean, dry and cool place.
② Connect the wires as the guide photo above
③ Using the storage mode, program and store Full, Half, Empty and "Power on" positions.
④ Use the power-on mode to program how you want the instrument to operate when the car starts.
⑤ Run and check in the run mode.
⑥ When adjusting the screw, move the pressure gauge from full to empty to avoid hysteresis error.
⑦ Some meters move very slowly. Please wait for the time to stabilize.
⑧ The tank sensor must have the same grounding as the FM101, otherwise it will cause unstable readings.
Store mode
① Turn off the power supply. Wait for 5 seconds. Press the "F" switch and turn on the power, then release the "F" switch.
② Only the red LED will light up
③ Set the fuel resistance to the full position. Use the calibration screw to adjust the meter to full, press the "F" switch and then release it.
④ Set the fuel resistance to 1/2 gear. Use the calibration screw to adjust the meter to gear 1/2. Press and release the "H" switch.
⑤ Set the fuel resistance to Emptv. Adjust the meter to be emptied using the calibration screw. Press the "E" switch and release it.
⑥ Adjust the calibration screw to the position where you want gatne o when the car is started. (Usually this is the position of the pointer when the car is closed)
Press "E" and "F" simultaneously and then release.
Boot mode
① Shut down. Wait for 5 seconds.
② Choose where you want the instrument to start when the car starts (usually the instrument "off position")
If you want the meter to start from the transmitter position. (Suitable for damped bimetal and cross-coil meters)
Press the "E" switch to turn on, and release the "E" switch.
If you want the meter to start at the preset position (set in step/6 of the storage mode). (Applicable to instruments without damping) Press the "H" switch and turn on the power, release the "H" switch.
③ The green LED will light up.
Operating mode
① Turn off, wait 5 seconds, and then turn on.
② The green LED will light up.
Features:
★As the interface between the fuel transmitter and the meter, it can read any fuel transmitter and is suitable for any electricity meter.
★Accurately correct the unstable motion caused by OHM mismatch and fuel sloshing, and customize the calibration for empty, half-level and full.
★The fuel gauge is designed for specific ohm range.
★Different car and meter manufacturers use different ohm ranges to properly operate their meters. This can cause problems for people who update their vehicles with new gauges or new fuel tanks and fuel transmitters.
★This module will allow you to use the stock transmitter with any fuel gauge and vice versa.
The package includes:
1X fuel gauge interface
- We maintain high standards of excellence and strive for hundred percent customer satisfaction. Feedback is very important to us. We hope that you contact us immediately before you give neutral or negative feedback, so that we can address your concerns. It is impossible to address issues if we do not know about them!
