496 Fuel Tank Filter Assembly with Wrench Replacement for Gasoline and Diesel Water Separate 30 Micron Max 25 Gpm 150 Psi with 1” NPT Top Cap Replace# B10-AL
About this item
[COMPATIBLE WITH FUEL TYPE] Fits common fuels such as unleaded gas, diesel, fuel oil, up to 20% biodiesel and related additives.
[FUEL FILTER ELEMENT] Keeping a clean 496-5 filter in your vehicle can reduce damage done to your engine and other fuel delivery components. 30 microns, provide high flow rates and superior filtration efficiency, protect fuels from particles such as rust, sand, dirt and water. With protective sheet to prevent the filter element from being destroyed or deformed by pressure.
[TOP CAP] With 1" NPT pipe fittings inlet and outlet marked at the top of the cap.
[HYALINE BOWL] Use 495-4 fuel tank filter bowl, makes it easy to visual monitor the fuel flow, the fuel flow will slow down when you need to replace the element. Drain valve installed at the bottom to drain water.
[FEATURE] Additional matching wrench and tape for easy installation and replacement. Flow rate max 25 gpm. Working pressure up to 150 psi. Gravity flow rate is approximately 5 gpm.
Suitable fuel type:
This tank filter is designed for use with gasoline, diesel or 20% biodiesel (B20) fuels.
Interchange Part Number：675-B10-AL-AB
Manufacturer Part Number：B10-AL
Feature:
Fuel filter element: 30 microns with protective sheet
Height: 9.5”
Inlet/Outlet size: 1” NPT
Hyaline bowl with drain valve
Flow rate: Max 25 gpm
Working pressure: Up to 150 psi
Gravity flow rate: Approximately 5 gpm
Installation:
1. Attach filter top cap to storage tank valve on opening marked “IN”.
2. Attach hose and nozzle to filter opening marked “OUT”.
3. When installing the element and bowl, apply a coating of oil to each side of gasket.
4. These components should be hand tightened only. Over tightening of the filter bowl will result in difficulty in removal at a later date.
5. When assembly is complete, check for leaks.
