INTRODUCTION

Product Name ： 3 string 12.6V40A lithium battery protection boa rd Chargingvoltage：DC12.6V~13.6V

Continuous discharge current：40A maximum (if the heat dissipation environment is not good， please reduce th he load current)Continuous charging current：upto20A

BalanceVersionProductsize：41*61*4mm EnhanceVersionProductsize：41*55*4mm Applicable choice：applicable to the nominal voltage of 3.7V， full /charged 4.2V lithium battery (including 18650， 26650， polymer lithium battery) ， can bed riled below 170W


NOTE

Note1：Successfullystartthedrillrequires310C-20Cpowerbatteries， or65C-10C power batteries(recommended power battery models：sony vtc 4， vtc4A， vtc5A， vtc 6) OV and 12.6V cable， use Copper wireof3squaremili meters or more(nickel sheets can not be used)

Note2：Strictlyconnect0V， 4.2V， 8.4V， 12.6V according to the diagram.Do not touch any components on the board when soldering the wire.Do not intentionally short circuit.

Note3：Whensolderingthebatteryforthefirsttimeorwhenchargingisinprogress， as long as the single battery exceeds 4.2V， the"430"resistor will heat up and discharge(discharge to about 4.19Vtostop heating) .If the"430"resistor is severely hot， check if the wrong line is connected.

DataCaciques

 

INTRODUCTION

Product Name ： 3 string 12.6V40A lithium battery protection boa rd Chargingvoltage：DC12.6V~13.6V

Continuous discharge current：40A maximum (if the heat dissipation environment is not good， please reduce th he load current)Continuous charging current：upto20A

BalanceVersionProductsize：41*61*4mm EnhanceVersionProductsize：41*55*4mm Applicable choice：applicable to the nominal voltage of 3.7V， full /charged 4.2V lithium battery (including 18650， 26650， polymer lithium battery) ， can bed riled below 170W


NOTE

Note1：Successfullystartthedrillrequires310C-20Cpowerbatteries， or65C-10C power batteries(recommended power battery models：sony vtc 4， vtc4A， vtc5A， vtc 6) OV and 12.6V cable， use Copper wireof3squaremili meters or more(nickel sheets can not be used)

Note2：Strictlyconnect0V， 4.2V， 8.4V， 12.6V according to the diagram.Do not touch any components on the board when soldering the wire.Do not intentionally short circuit.

Note3：Whensolderingthebatteryforthefirsttimeorwhenchargingisinprogress， as long as the single battery exceeds 4.2V， the"430"resistor will heat up and discharge(discharge to about 4.19Vtostop heating) .If the"430"resistor is severely hot， check if the wrong line is connected.

DataCaciques