|
Features:
1. It is great to
have in car in case of emergencies.
2. Powered by any
jump starter with a 12V outlet into an OBD II Memory Saver.
3. Preserves
vehicle codes and electronic presets.
4. The reinforcing
clamp, stable current, fixed sheath, safety insulation.
5. Easy to replace
and install.
6. 8amp fuse built
into the memory saver, better reliable on overload protection.
7. Interface
connector between a 12V DC power source and vehicle's OBD II interface.
8. This device can
work with any 12V DC power source, including jump starter, DC 12V Lead-acid
battery, or another car's DC 12V power outlet.
9. The device can
also get the 12v power supply from cigarette lighter of another good car.
Specifications:
Condition: 100%
Brand New
Color: As Pictures
Shown
Material: ABS
Weight: 259 g / 9.1
oz(approx.)
Warning:
1. When working
with the vehicle's battery, review all the battery manufacturer's and vehicle
manufacturer's safety instructions, warnings and directives regarding battery
disconnection, removal and replacement.
2. The vehicle's
electrical system is receiving power from memory saver through the OBD
connection. Therefore, the vehicle's battery connectors are electrically live
and should be covered with an insulator to prevent the connectors from touching
metal or each other and causing a short circuit. After each use, disconnect the
memory saver and use a dry cloth to wipe all dirt or oil from the connectors
and the cable.
3. During battery
replacement, DO NOT turn on (ignition) the car, which its old battery is disconnected
and new battery not yet finished replacement. As well, DO NOT turn the key on "ACC ON". If not, the fuse of the memory saver probably burn out, due to high
amp and overload.
4. Security attach
the OBD II connector of memory saver into your car OBD II port to get a good
contact, if not, during battery replacement, the bad contact between the OBD II
connector and your car, may cause missing power supply on your car ECU
(Electronic Control Unit, or called auto computer).
Troubleshooting:
The 12V DC plug
of memory saver should be correctly connected 12V power source, if not, the red
led light on the plug will not light up, that means no power signal from the
power source or with incorrect polarity connection. If the power source from
another car, then check whether the car's Cigarette Lighter on good condition
or not. If the power source from a jump starter, then verify if the cause is
from the contact. If the power source is from an alternative 12V Lead-acid
battery, then check whether the polarity correct or not.
Package List:
1 * Cigarette Lighter- Auto Jump Starter Power Converter
1 * Cigarette
Lighter -Clip Power Converter
|