* This Listing is for 2 Supports which fit the Following Applications :
2014 FORD Focus Ambiente Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2012-2015 FORD Focus S Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2015 FORD Focus SE Appearance Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2013 FORD Focus SE Plus Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2012-2015 FORD Focus SE Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2012 FORD Focus SEL Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2013-2015 FORD Focus Titanium Plus Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2012-2015 FORD Focus Titanium Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2014 FORD Focus Trend Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2014 FORD Focus Trend Sport Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2016-2018 Ford Focus S Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2016-2018 Ford Focus SE Appearance Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2016-2018 Ford Focus SE Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2016-2018 Ford Focus Titanium Plus Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
2016-2018 Ford Focus Titanium Sedan 4-Door Trunk-Damper, To Slow Down Trunk Opening, Sedan ONLY
Extended Length: 19.20 inch
Compressed Length: 10.80 inch
*How to Install :
*Installation Requirements:
1. Use Safety stands whenever a procedure requires you under the vehicle or supports. Or have someone hold the lid open for you so that they can raise or lower it as needed.
2. Before removing the old lift support, inspect the end connections and compare them to the units on your vehicle to make sure that they are the same As well as the extended length.
3. Lift Supports need to be installed fully extended. In most cases you just can't compress them unless they are on the vehicle. Never force a support.
4. If the ends are not lining up the support may need to be turned. To do this attach the shaft end of the support to the vehicle and then turn the entire body of the support clockwise unit the ends line up.
5.Once installed, check for looseness. If you have any problems during the installation PLEASE contact us.