F405 V3 30*30

Main control:STM32F405

Gyroscope:BMI270

Barometer:Type-C

OSD chip:built-in

Bluetooth-compatibility BLE:support,for reference adjustment

Connection mode:support 6PIN socket direct insertion,welding wire connection two ways

MicroSD card slot:support

Please use SDSC/SDHC type microSD card below 4GB, and must be formatted as FAT16/FAT32 format

Do not use SDCX type card(Betaflght only supports up to 4GB)

Ammeter input: Supported,with BLS 50A ESC

Please set Scale=386,Offer=0

Camera Adjustment Pad:Support(Front CC pad)

Input Voltage:3S-6S Li-Ion Battery(via 8PIN connector on the back or G,BAT pins/pads in the pads)

5V BEC output:9 groups of 5V outputs,total current output is 2A

9V BEC output:2 sets of 9V output,total current output is 2A

3.3V BEC output:1 group,maximum current 500mA

4.5V BEC output:2 groups,maximum current is 1A

ESC signals:back M1-M4 and front M5-M8

UART serial port:5 groups

ESC Telemetry Revenue:R4(UART4)

I2C:Supported,for magnetometer,sonar,etc

Legacy Betaflight LED pads:Support,For BF control of WS2812 LED lights

Buzzer Pad:Support

BOOT key:support,press and hold the BOOT key to power on the device,it can enter DFU mode, For brick rescue and firmware brushing

RSSI pad:support(labeled as RS)

SmartPort:support,use any set of serial ports to get Tx are available

Support firmware type:For BetaFlight,EMUFlight,INAV

Mounting hole:30.5*30.5MM(4MM hole)

BLS 50A 30*30

Firmware:BLHeli-S JH-50

Wireless Adjustment:Support

Continuous current:50A*4

Maximum current:50A(sec)

External capacitor:1500uF high frequency low resistance capacitor

Input voltage:3-6S Li-ion capacitor

Output voltage:VBAT

Ammeter:Support(Scale=386,Offset=0)

Package includse:

1Set*BLS 50A 4-in-1 ESC(optional)

Note:

Only the above package is included

The actual product contains the logo,hope you don't mind

Betaflight requires Micro SD card type to be SDSC or SDHC,SDX is not supported

It can only recognize up to 4GB and must be formatted in FAT16 or FAT32 format