Specifications:
Name: Electric Inflatable High Pressure Pump
Advantages: Long working time, Long service life and Better structure
Power supply: 220 V to 50 Hz
Power: 8a-10a
Working pressure: 0-30 Mpa
Available capacity: 0 p6,8 L
Speed: 2800r per min
Cooling mode: water cooling
Power: 1800w
Compression mode: Secondary compression
Weight: 17 Kg
Lubrication mode: oil splash type
Size: 34 Cm as37 Cm as18 Cm
Working noise: 70 Db
Use time: 6.8 L (45 min); 0.5 L (5 min); 0,45 L (4 min); 0,35 L (3: 40 min)
Main applications: high pressure testing, bottles, automobiles
Operation of the electric air pump:
Check the amount of oil before each use. The oil should exceed the red dot, but not too much. The Oil Exported Abroad Will Be Taken Out And Must Be Added Itself.
Reinsert the stopper. (Very important) Change the oil cover used for transportation for a striped breathing stopper.
To install the water pump, you must place the water pump in the water. The more cold water, the better. After the water pump has circulated normally, the electric air pump can be switched on. Manual shutdown After reaching the required pressure, the entire process must be observed. And it is forbidden to walk.
The mechanical pressure gauge screws the pointer directly to the desired value
Pressure. When the pressure rises to the set pressure after start, it stops automatically.
Loosen the bleed screws on both sides before staring at the machine. (Remember that the machine must start under zero pressure. If the bleed screw is not loosened, the machine will not start. After specifying the machine, pull the bleed screws on both sides to press normally. After the end of inflating, loosen the empty screw and let the air out. Then remove the inflating joint.
Press the "Set" button to set the desired pressure. Press "on" On
Start the machine. When the pressure rises to the set pressure, it stops automatically.
Packing list:
1x air pump
1x manual