1. Odometer Cluster correction -- Mileage adjust, Write/Read cluster, Read/Write EEPROM, Read/Write Flash
2. Key Programming-- Add/Erase Key, All Key Lost Programming, Programming Remote, Key Numbers Reading, Reading Pin Code , Reading EEPROM Chip, Remote Matching
3. Multi-language: English, Spanish, Polish, Portuguese, French, German, Italian, Russian
4. 7 inches touchscreen Android Tablet
5. Support 11 Special Function: Oil Reset Service, ABS Bleeding, Gear Learning, CVT Reset, Battery Match, EPB Adaptation, TPS Adaptation, Steering Angle Reset, D-P-F Regeneration, Injector Coding, Suspension Matching
6.Full OBD2 Function Check 
7.One Click Update via WIFI

8. Dealer Code: 0086B002   

✅1. Oil Reset Service
Allows you to reset the service lamps on the instrument cluster. The Service Indicator System is designed to alert the driver when the vehicle is due for a service.

✅2. ABS Bleeding
When the ABS contain air,the ABS bleeding function must be performed to bleed the brake system to restore ABS brake sensitivity.If the ABS computer,ABS pump,brake master cylinder,brake cylinder,brake line,or brake fluid is replaced,the ABS bleeding function must be performed.

✅3. Gear Learning
Crankshaft position sensor adaptive learning.

✅4. CVT Reset
This function is reset the adaptive shift

✅5. Battery Match
This function enables you to perform a resetting operation on the monitoring unit of vehicle battery,in which the original low battery fault information will be cleared and battery matching will be done.

✅6. EPB Adaption
Allows you to perform the service and maintenance of brake systems

✅7. TPS Adaption
This function allow for an idle relearn to be performed.

✅8. Steering Angle Reset
To reset the steering angle,first find the relative zero point position for the car to drive in straight line.Taking this position as reference,the ECU can calculate the accurate angle for left and right steering.After replacing the steering angle position sensor ,replacing steering mechanical parts(such as steering gearbox,steering column,end tie rod,steering knuckle),performing four-wheel alignment,or recovering car body,you must reset the steering angle.

✅9. D-P-F Regen
D-P-F Regeneration is used to clear PM(Particulate Matter)from the D-P-F filter through continuous combustion oxi-dation mode(such us high temperature heating combustion,fuel additive or catalyst reduce PM ignition combustion)to stabilize the filter performance.

✅10. Injector Coding
Writing injector actual code or rewrite code in the ECU to the injector code of the corresponding cylinder so as to more accurately control or correct cylinder injection quantity.After the ECU or injector is replaced,injector code of each cylinder must be confirmed or re-coded so that cylinder can better identify injectors to accurately control fuel injection.

✅11. Suspension Matching
This function can adjust the height of the body.When replacing the body height sensor in the air suspension system,or coontrol module or when the vehicle level is incorrect,you need to perform this function to adjust the body height sensor for level calibration.

Kind reminder:  The above list of cars is for reference only and does not mean that all cars are supported ！！！
Due to different car models, the car’s own system restrictions are different, and no equipment can support all car models . 
If you are not sure whether this equipment meets your needs, please contact us to confirm before buying, to save your time. thanks