Features:

1.This product is made of environmentally friendly plastic material, 3D printing process, and the part that fits with the fuselage is affixed with sponge protection;

2.This product supports a variety of camera mounting methods, can be mounted on top or bottom, can also be used as a handheld takeoff and landing;

3.This product with 1/4 screw connection, support all panoramic cameras and sports cameras with 1/4 screw holes;

Warm tips:

This product must be handheld takeoff and landing or find a hollow frame in the middle as a takeoff and landing support, be sure to close the downward vision obstacle avoidance before operation!

Products belong to the 3D printing custom products, installation need to pay attention to the location, screws need to tighten (loose will produce resonance shaking), but can not be too tight (too tight will blow up), storage and use of the temperature of -10 ~ 40 degrees Celsius, do not put in the car in the summer storage, more than 60 degrees is likely to lead to deformation. The products sold are all accessories, not including drones, cameras, etc.. As each camera and flyer operate differently, the flight must be the first short pole, low altitude test good stability.

Specification:

Material: PLA 

Net weight:50g

Product size:11*11*3.5cm

Suitable for DJI Air 3 drone

Packaging included:

1*Mounting Bracket

Notes:

The price tag only includes the stand, not including the demo drone and camera.