Immediate Strength Development
This fast-curing automotive window glue boasts exceptional bonding power.
One application of the glass adhesive glue is all it takes for permanent weather-resistant protection.
From windshield and glass sealer to RV window sealant, this compound can do it all.
Directions for Use:
- Detach wipers and accents, then use a utility knife to slice through the current urethane sealer
- Remove existing glass with care, and carefully clean debris from all surfaces
- Align and dry set the new glass using tape strips for positioning. Once marked, remove the windshield
- Remove the majority of the old car glass adhesive from the pinch-weld, leaving only a small layer
- Apply single-step primer* to any bare metal and conduct any required abrasive cleaning
- Clean the interior surface where contact will be made with windshield and glass sealant
- Apply a thin layer of primer* around the edge and let dry
- Cut the applicator tip on the windshield leak sealant to desired size
- Directly apply this windshield mount adhesive over the old auto window sealant
- Position the glass using the tape markings, and press into place to complete contact
- Squeeze out extra urethane windshield adhesive, or fill voids if necessary
- Remove the tape alignment strips, reattach moldings, wipers, and other accents
- Finally, clean up any excess windshield urethane adhesive
* To use without primer, ensure the bonding surface is free from contamination prior to application of the car windshield sealant.
The glass must also be pre-cleaned with a non-antistatic glass cleaner.
Additional Instructions: Designed for use at an ambient temperature of 42-95 F.
Place the car windshield adhesive in a plastic bag and submerge it in hot water before use for best results.