Features:
* You will get 1 set of DIY clock parts for a 25-30 cm diameter clock panel.
* Made of high quality materials, high quality manufacturing process, strong and , excellent service life!
* These clock repair replacement parts are suitable for cross-stitch, three-dimensional embroidery, craft clocks, frameless pull clocks, especially suitable as replacement parts for DIY quartz wall clocks.
*This product is accurate timing, time error within 1 second, service life up to 3 years, low power consumption, very environmentally friendly, ordinary batteries can be used for 6 months.
*This movement uses 1 section of 1.5V-AA batteries (carbon batteries can be used, alkaline batteries are not recommended, otherwise the current is too high, affecting the time, no batteries are used for delivery)
*This product is suitable for craft clocks, wooden wall clocks, metal wall clocks, electric box wall clocks, porcelain crystal paintings, repair and replacement, DIY home decorative clocks; it can rejuvenate your old clocks and make your new DIY crafts more perfect.
*No ticking sound, only the sweep of the second hand instead of ticking, making the movement more quiet.
Detail:
Material: plastic, metal
Color: A black, A black red, A black second hand point, silver, silver red, silver second hand point, B black, B black red, B black second hand point
Size:
Movement Dimensions:
Movement specifications:56*56*16mm , shaft length 13mm, thread height 6mm, suitable for 2-3mm thick clock plate.
The size of the pointer: as shown in the picture
Battery: 1 x 1.5V-AA battery (battery not included in delivery)
Package Contents:
Delivery list: clock movement, hands, accessories
Caution:
1. Due to various factors, such as monitor brightness, light brightness, etc., the actual color of the product may be slightly different from the picture on the website.
2. Please allow slight manual measurement deviation in the data.
3. Please refer to the installation diagram of the pointer to understand how to install the pointer.
4. After the three pins are installed, the three pins should be parallel when viewed from the side, and it is best not to touch the pins.