RAM ProMaster Driver Side Solid Window WITH BONDING KIT AND U TRIM
Driver Side Sliding Door
RAM ProMaster MWB 136" L2 Models
RAM ProMaster LWB 159″ L3 Models
RAM ProMaster XLWB 159" L4 Models
Includes:
1 x RAM ProMaster Driver Side SOLID Window As Pictured
1 x Bonding Kit (2 x Tube Kit)
1 x U Trim Used To Cover The Cut Edge
Window Specs:
- All our glass meets international safety standards these include: Worldwide Dot Standards, USA Federal Motor Vehicle Safety Standards
- E-marked and AS Rated
- Toughened safety glass
- Bonded window – No external seal or gasket
- Privacy Stained glass (not a tinting film)
- Tinted to 80% allowing 20% of light to pass through
- Made in Europe
- CNC Machine cut and finished
- Black ceramic (silk print) round the internal circumference of the glass so you can’t see the cut metal work
Bonding Kit:
- 2 x Tube Sika Urethane Adhesive
- 2 x Adhesive Nozzle
- 2 x Primer Stick with applicator
- 2 x Glass Wipe/Panel Wipe
- 1 x Bonding Kit Instruction Manual
U Trim:
- Used To cover the cut edge
- Goes over both the inner lip and cut edge
- Gives a neat and tidy professional finish
- Supplied in the appropriate length for the window purchased
Fitting Kit Tips and Hints:
To achieve a structural bond between glass and metal work the surface must be clean and free from grease or dirt. Use the cleaning wipe on the glass and metal work.
Primer is applied to both surfaces. The metal work and the metal work. Primer must be in contact with the adhesive.
The adhesive (urethane) is a vehicle glazing specific product, Urethane has a fairly thick consistency, if it was runny it wouldn't stay in place when the adhesive is applied or when the window is pushed into the adhesive. To aid its application its recommended to use a caulking gun with a higher lever ratio.
Pre Heating the adhesive tube prior to use is also beneficial if your using a standard caulking gun or a higher ratio adhesive gun.
A heat gun/hairdryer can be used for this to gently heat it.
The adhesive must be applied in one continuous run on the metal work with no gaps. Gaps means leaks!
The U Trim is used to cover the cut edge. Its fitted before the window is bonded in and trimmed to length. To fit simply push the trim over the factory metal stampings and the outer cut edge.
We have fitting videos online to share with you if needed and we are also available Monday to Friday 9am to 4pm to answer any fitting questions you might have.
Please use appropriate protective equipment when fitting.
If in any doubt get a professional in to do the job for you, goes without saying that Van Tek Glass Accept no responsibility for fitting or the inability to fit.
