• Freedom PMG (PERMANENT MAGNET GENERATOR) WITH 14 MAGNET ROTOR.
• one heavy duty bridge rectifier for converting 3 phase to dc output. 
• Mounting Bracket and Heavy Duty 2 arms tail assembly. Hot dipped Galvanized !
• Tail fin measures 29" tall for maximum tracking. 
• No slip rings to fail or replace. Wire tension system.
• Comes with 11 nylon carbon fiber composite blades. 
• Aerodynamically tapered Genuine RAPTOR GENERATION 4 Blades ™ for maximum output.
• Steel blade hub is 1/4" x 9'' Zinc Plated
• Blades Make  63" dia.  
• Mounting Bracket Fits on 1.5" schedule #40 or #80 pipe.
• 125,000 hours + of rated bearing life.
• Freedom PMG has no brushes, Stainless steel rotor shaft, very dependable!  
• Heavy duty Hub spacer/stabilizer 
• 11 blade Turbine weighs 53 lbs.  
• Limited Warranty (click here for details)
• box size 30" x 10" x 8"
    

Comes prewired for plug and play with:

• divert load
• 3-phase brake switch
• charge controller with LED volt meter
• relay
• heavy duty battery cables
• and rectifier for 3-phase output wind turbine connection

You can also attach additional DC wind turbines and solar panels to the board. 

Some of the key features of this hybrid controller are: 

• Dual microprocessor controlled for stability and accuracy
• Multiple user changeable settings and trip points for many various system requirements and applications. You can change the dump point voltage level, 
• end of dump voltage level, and length of time in divert mode when end dump point voltage is reached (between 0 to 999 seconds, or 0 to 999 minutes)  
• Isolated Electronics Protection - Almost impossible to accidentally connect wind or solar directly to the circuit board
• On board relay isolates electronics from back voltage spikes from large 440 amp relay. This is important to get the longest life out of the electronics. No one else has this!
• High amp rating - Can be operated at 100% duty cycle conducting surge loads up to 440 amps or 10,000 watts. Please note that the normally closed contacts can handle 100 amps continuous duty. 
• Battery Status LED lets you know your battery's actual voltage!
• Green LED on board lets you know the controller is in dump mode
• Plug & Play: Long leads for easy termination to your 12 volt battery or battery bank
• Can divert the charging source from the batteries to the load or dump both the batteries along with the charging source.
• Connect both wind and solar at the same time
• Reverse polarity protection
• Ultra low power consumption, even with the volt meter on (almost negligible).The volt meter can be set to turn off after periods of inactivity.
• Comes with 5 feet of heavy duty cables.
• Comes completely prewired as shown above.
• Mounting Plate Dimensions: 12 inches x 12 inches

Wind turbines for the beginner How to part one by Missouri Wind and Solar - YouTube

Video will open in a new window

[isdntekvideo]