Silicone Oil For Treadmills

Large 500 Ml Bottle & FREE DELIVERY

In respect of our loyal customers we have maintained lower prices on all sizes

Most treadmills require frequent lubrication of the running belt / deck. dependant on on make they require one of three lubricant types

Silicone oil

Silicone emulsion

Wax

please check in your hand book or on manufacturers website for this information. there are models that are self lubricating these are the really top end makes/models

The most common type used is "Oil" and this is more common with the domestic models on the market.The oil we supply is 100% silicone oil or otherwise known as  (Polydimethylsiloxane) try saying that after a couple of drinks. This oil is also of low viscosity so as to allow better spread between belt and deck.

why lubricate? lack of lubrication can cause excessive wear to both belt and deck due, when in use you are trapping the belt between your feet and the deck, this increases the friction and without proper lubrication places excessive stress on the belt, drive motor and rollers.

It is recommended that once a month dependent on usage! you should clean between the belt and deck to remove built up dirt. Builders wipes are great for this as most makes will remove the old oil as well.Baby wipes also do the job as well as cleaning crayon of the walls. Check the machines instruction for the amount of oil required if in doubt 10ml is about average but don't over do it you simply need a thin film of it on the deck. there is plenty of information on the internet regarding this subject so you should not have a problem.

As an added bonus Silicone Oil has many more uses then this, use it to oil locks it stops them freezing. use it for lubricating small bearings and bushes. for polishing plastics but it makes it slippy! and a lot more uses.

ATTENTION

Spouts: do not over tighten spouts they are plug style cap and do not require anything more than finger tightness to seal. using to much force will result in the top of the cap separating from the thread body, this is NOT a fault of the spout but is due to excessive force being used to tighten the spout onto the bottle. Spouts are resilient and  flexible we have even stepped on them and they have withstood this with no breakage 

Please note picture is for reference to sizes we do, you will only receive the size you purchase. thank you