Aftermarket Speaker Adapter

As the manufacture of this item we will not be undersold so get them here for a lot less. If you are looking to buy in volume please contact us for an ever lower price.

Features:

• Includes rubber trim to fit snug on your farings!
  

• Our adapters turn your factory glove box into a 6 1/2" speaker or your Factory 5 1/4" speaker opening into a 6 1/2" speaker ( these will not work if you have ever changed out your factory fairings and installed aftermarket ones) 

• Mold Injected: Stronger and More Durable.
• Nice Clean, flawless finish all the way around.
• Support guides in mold for easy installation: Our adapters have built in “Screw Guides” so when installing the product there’s not much room for mistake. The guides help you to line up the holes more accurately. Screw guilds also bottom out on the surface of the factory fairing so that that adapter and the fairing are held together as one unit.
• Our adapter are labeled L (Left) and R (Right). When sitting on your bike L is your Left and R is your right.
• For the adapters to fit right you will have to remove the fairing then reinstall after you have the adapters are fitted properly. 
• Our Adapters have specific curvatures to match up with your pods.
• Mounts to Factory Glove Boxes and/or the factory speakers that are in the lower fairing.
• Fits 6.5" Aftermarket speaker with cut out diameter 5 inches or less

Fitment:

Special Note:

Please Double Check!!! Please be sure to look at our pictures and make sure your glove box has the same curvatures.

Other models that are currently on the market are made by using use “blow molds” to form their products, this means they are more flimsy and not as stable. Ours are made out ABS through a molded injected process and are a lot stronger. Also with the "blow molded ones when screwed down there aren’t any support guides for the screws, so when over tightened they will have a tendency to warp or even crack.

If you look at your competitors you will see all they have are dimples where the screw runs though then to the factory fairing- the problem with this concept is that if you over tight the screw it will deform the weak plastic ( because it is blow molded)  or if you don't tighten it enough then the 2 pcs will not be held together at the right tension and will vibrate apart over time.