WARRANTY: All CHRA come with a 12 month unlimited mileage warranty

COUNTRY OF MANUFACTURE: UK

DISPATCH: Within 1 working day

BALANCED: Fully high speed balanced ready to fit (no further balancing required)

Contents:

2x Copper Washers for the Oil Inlet

1x Oil Drain Gasket

1x Compressor Housing O Ring

Oil Syringe

Balancing Certificate

Installation Guide

 

Every part is BRAND NEW, UNUSED and made to meet or exceed the OE equivalent. 

All components are designed and produced for heavy duty use and are fully balanced ready to fit, meaning no further balancing is required before fitment.

Fully High Speed Balanced 

Tested for Oil Leaks 

Tested for Vibration 

Tested for Noise 

100% Ready to fit 

Built in the UK

It is important that you ensure the turbocharger part number on your unit matches the numbers in this listing. There can be more than one CHRA for a specific vehicle, so this is the only way to ensure the correct fitment. Typically, the serial number is found on the alloy inlet housing of the turbocharger. Follow the pipe from the air filter to the turbo - the housing the pipe attached to is the compressor housing. On this housing should be a metal tag, or the numbers could also be found on a machined face.

Please ensure you are 100% certain you have ordered the correct part, if you are unsure, send us the vehicle REG or a list of the numbers on the turbo (or a picture) and we will confirm the unit for you. Turbo Rebuild cannot be held responsible for units ordered incorrectly.

 

When purchasing a CHRA from Turbo Rebuild, we are happy to offer an installation service to fit the CHRA into your turbo housings with a full calibration. Simply purchase the CHRA and installation service and send your turbocharger to our reconditioning centre. We will fully disassemble, chemically clean housings, actuator, nozzle ring (where used), before media blasting to ensure no contamination remains and the unit looks as near to new as physically possible.

All parts being reused will then be inspected to ensure are fit to reuse before the turbo is built back up with the purchased CHRA. The unit is then flow benched (where required) on our calibration rig and boost control is set and checked. The completed unit is then packed and dispatched back to your address. NOTE: All parts being reused must be in a perfect working condition and inside of OE tolerance, otherwise the parts will require replacement (we will contact customer in these instances).