1. The ambient temperature is not lower than +10 C and higher.
2. Prepare clean, non-marking wipes
particles.
3. Prepare Ethyl alcohol to remove fat from
surface.
4. Accurately measure the place for gluing.
5. Thoroughly clean the surface of the bonding area.
(Napkin with ethyl alcohol.)
6. These stickers can be applied without water. We also recommend dividing the parts of the stickers into small parts. To do this, you can cut the mounting film with scissors. It will turn out so that sticking in small parts will be more convenient than sticking a large sticker at once.
Since with water, small parts will not lag behind the transfer film on a wet surface. Stretch the stickers and stick them perpendicular to the engine cover, starting from the center.
7. For gluing small parts of stickers, they are covered with a translucent transfer film. We remove these parts from the
substrate (paper), together with small stickers, so that the small parts of the stickers are removed from the substrate along with the translucent film. Now we apply everything together on a dry surface. We press very well to the surface, while each particle of the stickers is well pressed. After that, the translucent film is removed, and small parts of the stickers remain glued to the engine covers.
8. After pasting, you need to wait about 24 hours. Attention.
You do not need to test for strength.
Good bonding takes 2-3 days.