This RL Drake Delrin High Quality Finger Divot for the C-Line Spinner Knob, is made to specifications of the original Drake C-Line spinner knob.

These finger divots are a perfect replacement for missing or old damaged spinner finger divots.

 To install, you slip the divot through the hole, cut to length so about 1/8 inch of the shaft is exposed on the back side, and touch a hot solder iron on the end lightly to slightly mushroom out the end so it stays in place.

 The are special made with a slight ridge on the circumference, to allow the divot to spin without binding.

  They were expensive to have made for a production run of original Drake C-Line spinner knobs, however the parts and mold to make the complete assemblies are gone for good so these are part of the over run.

 They will also work for other knobs to convert to a spinner knob if desired.

 I am selling them at my cost.

 Shipping in the USA is Free

 NOTE: The complete knob in the photo gallery is not included and is shown for reference only!

 If you do purchase an ebay item from me and for some reason are not satisfied or have questions, PLEASE contact me right away and I will take care of it to your satisfaction, (rather than leaving negative or neutral feedback before I am made aware of a problem). I sell hundreds of pieces of used and new gear and it is possible I could miss something or make an occasional mistake, but I will always work to make sure you will be satisfied or I will refund your full payment including the shipping cost, so there is no risk you will be stuck with something that you do not want. I know there are many sellers that do not much care about your satisfaction but I am not one of them! Please consider this before you bid on my items and before leaving any negative or neutral feedback.