1. The ambient temperature is not lower than +10 C and higher.
2. Prepare about 300 grams of water in the sprayer,
(preferably distilled water), and add to it
(pure soap without additives) a couple of drops or very finely
piece of solid. Mix well.
3. Prepare a felt spatula to remove from under
water and air drops stickers.
4. Prepare clean, non-marking wipes
particles.
5. Prepare Ethyl alcohol to remove fat from
surface.
6. Accurately measure the place for gluing.
7. Thoroughly clean the surface of the bonding area.
(Napkin with ethyl alcohol.)
8. Small parts of stickers can be pasted without water. Most of the
stickers, without experience, we recommend sticking with water.
Using water, the sticker can be moved to the sides.
9. Peel off the film from the back of the sticker, exposing
sticky side.
10. Apply spray water to large parts
decals on the adhesive layer, and to the surface on which
stickers will be applied.
11. Paste the sticker on the surface you need,
secure the sticker by pushing it into place and extrude
Accumulated drops of water with a spatula, removing drops
water to the edge of the sticker.
12. After pasting, you need to wait about 24 hours. Attention.
You do not need to test for strength.
Good bonding takes 2-3 days.