1. Removing
old emblem or emblems can done neatly by using a heat gun on the lowest
setting. Carefully pry the old emblem off using a putty scraper.
2.Then clean the area where the emblem adhesive still remains. Use adhesive cleaner and a clean rag.
3.Most
important step is to use rubbing alcohol on a different rag to clean
the remaining grease or dirt from the location. Allow it to air dry.
4.Using
a level or ruler to create a straight line parallel to the ground,
marking the location of the emblem against desired surface or body
lines. Use painter’s tape to make your guide lines.
5.Prepare
the emblem, making sure it's clean. Be sure to never touch the
application adhesive on the back of the emblem after Remove the
backing tape from the adhesive.
6.Hold
the emblem just above the surface in the desired location, using the
painter’s tape as a guide to keep the emblem level located properly.
7.Stick
the emblem on and hold it in place until the adhesive has had a chance
to setup bond on the surface of the vehicle. This usually takes 10
seconds.