2000W Wind Turbine Charge Controller 12/24/48V Waterproof Efficient Generator Regulator

Features:

1. 100% brand new and high quality

2. This controller controls the wind to automatically charge the battery.

3. When the battery is full, the fan is braked by the internal circuit automatic control. When the battery voltage drops to the recovery voltage, the fan resumes charging the battery, thus protecting the fan and the battery.

4. The rectifier and brake circuit part of the controller adopts integrated module .

5. waterproof protection, waterproof and waterproof, with protection level above IP67

6.This controller can control wind turbines to charge the battery automatically .When the battery is fully charged, brake can be controlled automatically by the interior circuit. When the battery voltage drops to restore voltage level, wind turbine can automatically recover to the battery charging, so as to protect the wind turbine and the battery.

7. Voltage and current limiting are be enabled during recharging to ensure the best charging effect. Meanwhile, it provides the maximum protection to the wind turbine and battery.

8. Unique reverse connect protection circuit. For improper operation the positive and negative of battery, don't need to replace the fuse, only to reset the positive and negative in correct point. So the whole system will be more reliable.

9. LED indicate circuit working condition, concise, intuitive, and clear

10. The comprehensive waterproof protection. If the controller without waterproof but used in easy ooze water environment or the humidity is heavy, then the controller is easy to be corroded and damaged. Our product adopts full seal completely waterproof design which adapt to the heavy humidity, salinity, such as ground water operational environment. The protection grade reaches the IP67 above, even in water can steadily work normally for a long time.

 

Specification:

*Condition: 100% Brand New

*Model: FW10-48-A

*Battery Rated Voltage: 96V

*Wind Rated Power: 2000W

*Brake Start Voltage (Factory Value): 60V

*Brake Recovery Voltage (Factory Value): 54V

*Display Mode: LED

*Working Temperature And Humidity Range: -35℃/+75℃

*Protection Level: IP67

*Product size:150×132×48mm

*Packing size:200x170x100mm

*Packing weight:1.5kg

*Quiescent current：≤15 mA

Operation Instructions:

1.First: connect the red and black lines with the "+" &"-" of the battery bank;when the green "Battery Light" lights on, which means that the battery is connected correctly, then can continue the second step.

2.Next: connect the three green wires with the output wires of the wind turbine generator.

The green "Charge Light" flashes, which means that the wind generator works and is charging the battery.Flashing speed shows the rotate speed of wind turbine generator.When the wind turbine generator is braking, the another red "Brake Light" will be on, which usually happen when the battery full charged or the wind speed too high.

 

Please be sure to notice:

1. the rated output voltage of wind turbine generator needs to be same with the rated voltage of battery bank.

2. the controller must firstly be connected with the battery, then can connect wind turbine generator.

 

Package List:

1 * Wind Controller