eBay

Fitment:

This pressure sensor is compatible with evolution CS or CTS, insight CS or CTS, and juice with attitude CS or CTS. This sensor must be used along with Edge Universal Sensor Input System(part # 98605), as this device will require the Universal Sensor Input (#98605) to connect to the CS2 and CTS2 Monitor

Fit for:

1999-2003 Ford 7.3L Powerstroke

2003-2007 Ford 6.0L Powerstroke

2008-2010 Ford 6.4L Powerstroke

2011-2017 Ford 6.7L Powerstroke

2001-2004 GM 6.6L Duramax LB7

2004.5-2005 GM 6.6L Duramax LLY

2006-2007 GM 6.6L Duramax LBZ

2007.5-2010 GM 6.6L Duramax LMM

2011-2016 GM 6.6L Duramax LML

1994-2007 Dodge 5.9L Cummins

2007.5-2018 Dodge 6.7L Cummins

Features:
1) The pressure sensor is a 0 - 100 PSIg 1/8-inch NPT sensor, The sensor features a tolerance of +-1.5% over a temperature range of -20C to 85C and a tolerance of +-2.5% over a temperature range of -40C to 135C

2) Use this pressure sensor to monitor data such as Boost PSI, Fuel Rail Pressure, Air Bag Pressure, Lift Pump Pressure, Pre and Post Intercooler Pressure, and many more
3) Great used for measuring PSI for a turbocharger, supercharger, fuel system, or anywhere you want to install them. Also suitable for monitor data such as Boost PSI, Fuel Rail Pressure, Air Bag Pressure, Lift Pump Pressure, Pre and Post Intercooler Pressure, and many more

4) Made of high-grade steel and rubber, this meets OEM standards or higher, with anti-corrosion, sturdy and durable

please follow these instructions:

STEP 1 - Apply a thread sealing compound to the sensor threads and insert it into the tapped hole. (This is especially important if there is potential for leaking)

STEP 2 - Use the 13mm wrench to tighten until snug. Do not over tighten to avoid stripping out threads.

STEP 3 - Locate the Pressure Sensor Adapter Harness included with the sensor.

STEP 4 - Plug the small round connector into the pressure sensor.

STEP 5 - Route the remaining connector and wire to the Universal Sensor Input.

STEP 6 - Plug the adapter connector into one of the accessory connectors.

Note: This sensor must be used along with Edge Universal Sensor Input System(part # 98605), as this device will require the Universal Sensor Input (#98605) to connect to the CS2 and CTS2 Monitor

Package included:

98607 Pressure Sensor