Product advantages:
1: Easy to use and install
2: Full automatic induction: automatically turn on the light after sensing people, the light comes on when people come, and the light goes off when people go. It is safe and energy-saving, and is not affected by sound, objects and other external factors
3: Sensitive sensing, accurate identification of biological and non biological movement, so as to minimize the misoperation rate.
4: Stable and reliable performance
5: Automatic metering: automatically identify the intensity of ambient light, and the light will be on when there are people when the lighting demand is set. Otherwise, it will not be on.
Product Overview:
When someone enters the sensor and reaches the lighting demand, the microwave switch will be automatically turned on, the load appliance will start working, and the delay system will be started. As long as the human body does not leave the sensing area, the load appliance will continue to work. When the human body leaves the sensing area, the sensor will start to calculate the delay. When the delay is over, the sensor switch will be automatically turned off, and the load appliance will stop working. It is really safe Full, convenient, intelligent and energy-saving.
precautions:
1. Please disconnect the power supply before installation to avoid danger
2. The product is not waterproof, please pay attention to moisture-proof and waterproof.
3. The microwave induction angle is 360 degrees. Please pay attention to the installation method.
4. The product has high voltage inside. Non professionals are not allowed to disassemble it, otherwise they will bear the consequences.
Test method used:
1. Ensure the correct wiring and installation of micro liquid sensor and load lamp;
2. Use of microwave sensor (ceiling mounted, gear set to 100% sensing distance)
Delay time 30 seconds, light sensing failure mode as an example)
Install the microwave inductor ceiling 3 meters above the ground to ensure the front of the microwave induction antenna
Horizontal downward;
Turn on the power switch once;
The microwave sensor enters the power on self-test stage: at this time, the brightness of the lamp is 100% and the duration is about
15-30 seconds, the brightness decreases from 100% to 0%;
The microwave sensor enters the environmental detection stage: at this time, the brightness of the lamp is still 0% and the duration is 15-30 seconds;
The microwave sensor enters the intelligent control stage: when someone enters the microwave induction coverage range (generally 5-8m radius), the brightness of the lamp is 100%. If someone has been living within the microwave coverage range, the brightness of the lamp will always be 100%; when people leave the microwave coverage range and the 30 second countdown is over, the brightness of the lamp will automatically drop to 0%;After 3 seconds, when someone enters the microwave induction coverage again, the lamp will turn on automatically100%, 30 seconds after the person leaves, the brightness of the lamp will automatically decrease to 0%
3. When testing sensors and lamps by mass-produced manufacturers, the delay time file can be placed in the test mode, and the others are the same as above
4. Test precautions and special instructions:
During the test (especially when the prototype is placed on the desktop and the induction antenna face up), people must be at least 1m away from the microwave induction antenna face;
After the light is off, it takes more than 3 seconds to trigger again;
During the test, try to eliminate external interference factors, such as machines with people moving or moving on the partition wall and low-frequency resonance, so as to prevent false alarm and misjudgment;
Before setting the dial switch parameters, the power supply of the microwave inductor must be turned off. After setting, it can be powered on again;
detailed list:
1 * microwave induction switch