Product Name: Portablehandheldspotwelder
Liquid crystal display; power/gear/delay/voltage/mode
Gear adjustment :80
Batterytype: lithium polymer battery
Battery capacity :5000mAh
Design curent:800A(MAX)
Enter interface:Typec
Inputparameter :5V/2.1A
Nickel strip thickness :0.1-0.2mm
Productsize :251*58 *25mm
Product weight:350g
Weldingmethod: The welding head is held at 60° with the
horizontal plane visually, and two needles are pressed on
the surface of the nickel sheet at the same time

Spotwelder operation guide
1. Please read the instruction scarefully after getting the product
2. Long press the switch machine, 6 minutes without any
operation will automatically shut down
3. Thethicknessofnickelsheetis0.1-0.2mm
4.After starting up,the product isinautomaticwelding mode
5. lf thewelding head is incontact with metal,it can be out put
once,and then itcan be lifted Welding next time
6. Ensure that the welding surfaceof thebattery is deanand
smooth
7.Make sure the nickel sheetis clean and flat
8. Set the spot welding machine,press properly to make the
welding need leand nickel sheet,nickel sheet and battery
contactis good,no hanging no badcontact you can be good
welding. Differentnickel thickness,usingdifferentgearsisnot
thegreaterthepower, thetertheeffect,users can try which
gear is more suitable.
9.Use Type-c charger to charge, 5V input(higher voltage is strictly
prohibited),use5V/2A charger.This product supports use while
charging

 

Product list

1X spot welder

1XType-c charging cable

1X Nickel chip