Two-headed Shoe Stretcher Machine Shoe-supporting Heating Device Repairing Shoe Machine

Product description:

The shoe repair machine is mainly used for shaping, wrinkle-reducing or positioning expansion of shoes that are not suitable for customers. It is widely used in machine repair shops, shoe stores, department stores and footwear wholesale markets.

Operating procedures and precautions:

1. Reasonable operating procedures are essential for improving efficiency and achieving the effect of shoes. When the first half is expanded, according to the needs of customers, it is necessary to figure out the exact parts that need to be enlarged, then apply enough soften leather water or shoe water to the part (shoe inside)

2. Select the corresponding aluminum mold nesting, note that the small mold or some broken skin and other corresponding soft materials should be fastened on the aluminum mold that needs to be enlarged.

3. Rotate the upper screw of the shoe machine clockwise until the front half of the shoe is full. When lengthening the shoe, please put a piece of broken skin on the heel of the shoe to avoid damage from inner lining of the shoe, tighten the screw on the shoe machine, just feel strong when you tighten the screw.

4. Under normal circumstances to 24 hours, in the middle, it is best to tighten the screw every two hours, if you want to speed up the speed of the shoes, it is best to spray the shoes on the inside of the shoe in a certain period of time.

Pay attention to the following points when smashing shoes:

1. Spraying the soften leather water to shoes must be on the inside. For light colors or other special shoes, be cautious and prevent the color of the upper from becoming darker.

2. When change to shoes, the screw is not the harder the better, this will damage the shoe machine, generally need to be every two hours tighten the screw, so that the shoes are in tension, the shoes can only be a big one,the code is about 6-7mm.

3. Must be clear about the texture of the shoes, shoes must be leather products.

4. Do not use the afterburner or use brute force, this will pull crack the shoes.

Maintenance:

1. Keep the whole machine sanitary, especially the screw part;

2. Regularly add lubricating oil or grease to the screw to keep the screw rotating flexible;

3. The surface of the aluminum mold is soft and should be placed in a place where it will not hit the external force;

4. It is strictly forbidden to use excessive force Rotate, prevent screw slippage.

5. The surface of the aluminum mold is best to regularly wipe the surface with a fine sand skin to prevent surface oxidation, affecting the service life and appearance.