About Receiver:
Model No.: ZM12V10A
Working voltage: 5V / 12V / 24V Optional
Quiescent condition: Less than 6mA
Working temperature: -40 Degree +80 Degree
Receiver sensitivity: more than -105dBm
Working frequency: 433mhz
Output voltage: DC and Switch Signal is optional
Max load current: Less then 10A
Size: 33*23*15mm
Box size: 46*30*22mm
Application: It is suitable for remote control modification of household appliances, industrial controller modification, remote control modification of access control system, wireless modification of garage doors, remote control of car rear trunk, remote control modification of various power switches.
About Transmitter:
Buttons: 1 Button
Operating frequency :433MHz
Remote Distance: 20-50M
Operating Current: 13 mAh
Encode: EV1527 code
Size: 5.7 x 3.2 x 1.1cm
Package Includes
1 x Transmitters (5V 12V 24V Optional)
1 x Receiver
1 x User Manual
or
2 x Transmitters (5V 12V 24V Optional)
1 x Receiver
1 x User Manual
About Working way:Working way changed by Learning button
Momentary: Press and hold the learning button until the LED light flashes 2 times(Relay: Press and hold -> On; Release -> Off.)
Toggle: Press and hold the learning button until the LED light flashes 3 times (Relay: Press -> On; Press same button again -> Off)
Delay 5 seconds: Press and hold the learning button until the LED light flashes 4 times(Press remote control button, the relay actuates and keeps working 5 seconds. )
Delay 30 seconds: Press and hold the learning button until the LED light flashes 5 times(Press remote control button, the relay actuates and keeps working 30 seconds.)
Delay 60 seconds: Press and hold the learning button until the LED light flashes 6 times(Press remote control button, the relay actuates and keeps working 60 seconds. )
About Learning and clearing Method:
Learning: press learning button 1 time ,the LED indicator ON, press the transmitter button A , LED indicator flsah 1 times, then press the transmitter button B ,LED indicator flsah 1 times and off , learning successfully.
Clearning: Press and hold the learning button until the LED light flashes 7 times, no longer flashes, clear code successfully, all remote controls will be out of function