Package: 2 PCS
Compatibility:
E-350 Super Duty 2004-2010 6.0L
E-350 Club Wagon 2004-2005 6.0L
E-450 Super Duty 2004-2010 6.0L
Excursion 2003-2005 6.0L
F250 Super Duty 2003-2007 6.0L/2008-2010 6.4L
F350 Super Duty 2003-2007 6.0L/2008-2010 6.4L
F450 Super Duty 2003-2007 6.0L/2008-2010 6.4L
F550 Super Duty 2003-2007 6.0L/2008-2010 6.4L
F650 2004-2008 6.0L
F750 2004-2008 6.0L
Replace Part Number:
FL2016,3C3Z6731AA,PF1704,61857312,CH9549,P7235,72242WS,57311,P550528,X5526,LF16166,LP2016,ML1034,7312.
Superior Filtration Media:
Optimally screening out 98% of abrasives such as carbon, sand, dust and bits of metal before they get into your oil.Helps protect against engine wear.Protect your engine and keep your emissions control systems working properly.
Pressure-relief valves:
Help minimize the chance of contaminated oil circulating back into the engine.Help maintain the supply of oil to the engine under extreme cold conditions or if the filter gets clogged.Silicone Anti-drain back valves help prevent oil from draining out of the filter and engine when the engine is not running and resist the aging effects that an engine’s high heat can cause.
Unique Elements:
Allow for eco-friendly disposal of used filters through biodegration, reducing impact on landfills.
Feature
Complete filtration of engine oil, which ensures high performing fuel injectors and long engine life.Optimally screening out 98% of abrasives such as such as carbon, sand, dust and bits of metal before they get into your oil.Helps protect against engine wear.Protect your engine and keep your emissions control systems working properly.Precisely engineered for your Power Stroke Diesel engine.The oil filter should be changed every 7,500 miles under normal operating conditions and 5,000 miles under "severe" operating conditions.
Installation instruction
1.Place a suitable drain pan (minimum 15 quart capacity) below the drain plug.
2.Remove the drain plug with a 19 mm or 3/4" box end wrench and allow the engine oil to drain completely.
3.Remove the oil filter cap on the top of the engine using a 36 mm socket.
4.Pull the oil filter and cap straight upwards to remove it from the filter canister.
5.Remove the oil filter from the filter cap by pulling it away from the cap.
6.Remove the old oil filter cap o-ring, Lubricate the new one with clean motor oil,then install it in place.
7.Install the new oil filter. Note that the oil filter clips into the oil filter housing. You will hear it snap into place if it is installed correctly.
8.Reinstall the assembly and torque cap to 25 Nm (19 lb-ft)
9.After adding the oil,run engine for 3 minutes and check for leaks.
