Mode of operation: Handheld

Power: 220v

Power: 400W

Welding current: 0-50A

Use range: Metal can be welded

This machine can be welded: 0.5-2.5mm weldment

Application of welding ring machine

 

Welding machine can be used for platinum, gold, K gold, silver steel fast welding,

on the mouth, melon seeds deduction, fine wire of the confidential welding.

Can be connected to argon protection, direct welding without

Solder powder, solder joints are smooth, not black.

one. Installation and commissioning

A. Electrode clamping output negative electrode, the electrode seat output positive pole.

B. argon is vented by argon and connected to argon

C. tungsten needle can be sharpened in the sand turbine, the use of cutting-edge discharge source work.

Inlet, argon pressure regulator to the most gas (with argon protection models apply)

D. tungsten needle installed when the welding head around 5MM, tungsten needle diameter 0.1mm

 

 Steps

 

1. Turn on the power and turn on the power switch.

2. Adjust the power knob, the general (coarse adjustment) to adjust the scale of 1 to 1.5

(fine-tuning) to adjust the scale value of 7 to 8 (according to work requirements can be adjusted scale value).

3. With tweezers sandwiched work, the workpiece interface alignment tungsten needle

(the best distance of 0.5mm), the workpiece can not tungsten contact.

4. With the foot pedal switch (remove the foot), spot welding to complete.

 

 Precautions

 

1. The foot can not be a long time stepping on the foot switch, step on immediately removed,

if a long time stepping on the foot switch, the machine is in a short circuit state, will burn the internal circuit.

2. Please use this machine for precision equipment.

3. Flash damage to the eyes, please use the protective measures.

4. When depressing the foot switch, do not touch the metal parts of the tungsten needle and tweezers at

the same time, otherwise there will be a sense of acupuncture.

5. Non-professionals, please do not repair, there are high pressure