Important Safety Warning:

1. Strictly limited to outdoor use only.

2. Please read the manual carefully before use.

3. Remove the key wench after adjusting the firepower to avoid high temperatures.

4. After use, please pour out the gasoline into a safe airtight container to avoid leakage of gasoline due to changes in environmental pressure during driving.

5. Never place an oil bottle with the cap open nearby while using the oil burner.

6. Never use any method other than this instruction to preheat the oil stove.

7. Never fill oil while on fire or smoking.

8. Never cover the oil stove with anti-wind shields, stones, or any other objects while in use.

9. If there is a small fire caused by gas leaking from the valve shaft, turn off the oil stove. Tighten the hex nut with the key wrench at a small angle until the fire is burned out. Reignite. Repeat the operation if necessary.

10. If there is any unexpected open flame or oil leakage during use, please put out the flame immediately and release the pressure of the oil tank. After the oil tank cools down, find out the cause and eliminate it before using it again.

Specifications:

Brand: ΣIWALKER

Model: G43S

Material: Stainless Steel, Brass, Carbon Steel

Dimension (Diameter*Height): 100*130mm/3.93*5.10inch

Weight: 460g/1.00 lb

Volume: 200ml/6.76oz

Fuel type: Gasoline/White Oil

Preheating Fuel: Alcohol/Gasoline

Power: 2200W

Friendly Reminder:

· It is normal that the valve switch on a new oil stove could be less smooth when starting to operate. ΣIWALKER suggests reading the manual carefully and being patient with the first use so that users can be familiar with all the functions of the oil stove.

·  It is normal that the oil tank becomes hot after using the oil stove for a long time. Please rest assured.

·  After turning off the valve, blow off the remaining fire with your mouth. Do not forcibly close the valve to avoid damaging it.

Instructions(Please read the manual carefully before use):

Turn the key wrench clockwise to the end to close the valve, and turn it counterclockwise to the end to clean up carbon deposits/clean the nozzle. Make sure the valve is closed before use.

1. Fill Oil: The maximum volume of the fuel tank is 200ML, and the amount added to the fuel tank should not exceed the neck of the fuel tank/MAX line. (Forbidden to fill full.)Please tighten the cap of the fuel tank.

2. Preheating: There are three ways to preheat the oil stove.

Method A(Recommend): Use alcohol to preheat. Turn the key wrench clockwise to the end to ensure the valve is closed. Add alcohol to the preheating cup(Be careful not to overflow). Then ignite the alcohol.

Method B: Use gasoline to preheat. Turn the key wrench clockwise to the end to ensure the valve is closed. Add gasoline to the preheating cup(Be careful not to overflow). Then ignite the gasoline.

Method C: Use the gasoline in the fuel tank to preheat. Turn the key wrench 70º counterclockwise to open the valve. Hold the fuel tank to warm up with your hands to vaporize the gasoline. The fuel will flow into the preheating cup. When there is fuel in the preheating cup(Be careful not to overflow), turn the key wrench clockwise to the end to close the valve. Then ignite the gasoline.

3. Ignition: When the alcohol (or gasoline) burns out, immediately turn the key wrench counterclockwise to release the gas from the nozzle and use a match or lighter to ignite it. You can adjust the firepower by turning the key wrench. Please remove the key wrench after adjusting the firepower to avoid high temperatures. Turn the key wrench clockwise if you want to lose it.

PS: Please keep it fully open during use. If you turn on a small fire, it will lead to insufficient heat, loss of temperature, and red fire, and it will easily lead to incomplete vaporization of fuel, which will accelerate the shortening of the life of the oil pipe.

4. Clean the nozzle: You can clean up carbon deposits whether the stove is in use or not. Turn the key wrench counterclockwise to the end and turn it back as quickly as possible. If you choose to clean up the carbon deposits during the use of the oil stove and the flame goes out during the process, please be prepared to ignite it again.