Introduction:
PC Hi-Fi Fan Interface Online Power Filter Purification Isolation Filter with Dual Isolated
to the filter ground, isolated the fan motor to the entire PC power
supply environment Interference, to avoid fan motor noise affecting
interference from other devices in the PC. Especially for miscellaneous Wave-sensitive
PC audio field, to eliminate ripple interference, you can get immediate
results. A good internal power supply environment has a positive
benefit to the stability of all powered devices. (PC power has always
been a shortcoming and drawback of PC Hi-Fi)
Elfidelity
Small Wind Sugar Fan Power Noise Filter filter uses a dual independent
parallel filter isolation design, stepped filtering, selected Japan Ina
Elna red robe fever audio, with Japanese Ruby RX30 professional power
supply filter capacitor, Together with polymer solid capacitors and
Philips BBC metal film capacitors, combined with TDK high-power
inductors, an excellent two-way filter is created to effectively isolate
the fan motor from the internal grid of the PC, purify the PC power
supply, and ensure the PC audio environment.
There
is also a blue LED on the Small Wind Sugar, which is not a decorative
vase, it is an indication of the operation of the Fan Power Noise Filter
filter isolator. If the LED is noticeably strobed, or the pulse is
extinguished. It shows that the interference generated by the fan is
greater than the maximum margin that the Small Wind Sugar can smooth the
peak burr. If this happens, I highly recommend not using this fan,
because its interference is too great, it may not only seriously affect
the stable operation of your PC, but also damage the surrounding
precision electrical equipment, such as hard disk.
The
installation of Small Wind Sugar is very easy. It comes with a backing
glue and distributes a 30cm 4pin woven woven snake thread. It can be
installed freely and is easy to manage and route. The only thing to be
reminded is that the small wind sugar is isolated design, the input and
output are directional, the power supply must be connected to the "IN"
interface fan connected to the "out" interface, otherwise the fan will
not work.