1.Operating Voltage:4-28V 

2.Operating Current:2.8mA (typical);3mA (max)

3.Detection Distance:5-9m

4.Transmitting Power:20mW (typical);30mW (max)

5.Output Voltage:3.2-3.4V

6.Output Voltage Driving Capacity:100mA 

7.Trigger Way:repeat trigger 

8.Output Control Low Level:0V 

9.Output Control High Level:3.3V 

10.Operating Temperature:-20~80 celsius 

11.Storage Temperature:-40~100 celsius 

 

Adjustment Part Introduction:

1.C-TM

  Adjust repeat trigger time,default trigger time is 2s;increasing capacitor's capacity will make repeat trigger time longer;and actual counting trigger time can operate as below:

  Stick capacitor on C-TM,test 9196 3-pin frequency F,repeat trigger time T=(1/f)*32768

2.R-GN

  Detection distance adjustment;connect with resistor and detection distance will become shorter;if not connect,detection distance is 7m;if connect with 1M ohm resistor,detection distance is 5m

3.R-CDS

  Internal VCC parallel connect with internal 1M ohm resistor to CDS pin (that is 196 9-pin) by R-CDS ,CDS connects with photoresistor,you can close detection function at night 

 

Pin Definition:

1.3V3:3V3 power output 

2.GND:ground 

3.OUT:control output;when detect moving objects,it will output high level 

4.VIN:input voltage,4-28V

5.CDS:enable control chip,lower than 0.7V,OUT will output low level all the time 

 

Package Included :

5 X  RCWL-0516 Microwave Radar Sensor Switch