RC Two-way Governor Speed Controller for Brushless Speed Reduction Group Stepping and Other Control Boards for RC Car
Features:
l With neutral point unlocking (the motor can only be started when the throttle channel is around 1500 to prevent it from turning on power)
l With out-of-control protection (loss of signal, for safety, motor protection, you need to return the throttle to the center and unlock it again)
Specification:
l Voltage: 6v-28v recommended 2-6S lithium battery (selected according to motor voltage)
l Bec output 5v 1A (using linear regulator, 4S or more to connect to the steering gear requires additional power supply)
l Board Size: 24x12MM
Instructions:
l Purchase a brushless motor with a circuit board of about 10K pwm drive that meets the requirements
l Solder the wire end of the brushless motor to the pad of the board (brushless motor +-must not be soldered backwards)
l Power-on test whether the brushless is normal
l If you want the motor to reverse, you can change the cw/ccw solder joints on the back of the board
l If the speed of the mid-position motor is the largest, the speed of the upper and lower levers becomes smaller, indicating that the controller needs a reverse duty cycle, and the H/L solder joints on the back of the board can be changed.
Packing includes:
l 1×RC Two-way Governor
Note:
l This product cannot directly brushless u, v, w three-phase coils, it must be connected to a brushless motor with a circuit board and a steering and pwm lead wire (brushless deceleration group more often)
