dash cam hardwire kit
clean
Extra Advantage


  • Compatible with 12-24Vdc for car or truck installations.
  • Perfect for 24/7 Parking Surveillance.
  • Low voltage protection protects against battery dying.
  • Works for almost all car micro USB device, such as dash cam、mirror cam、GPS navigator and radar detector
  • No need for cable from car cigarette lighter socket, replace it with a permanent hidden cable
  • Less static when you’re listening to the radio.
  • Installation in minutes with little to no expertise required.
  • 3.5 meter power cable included.
  • The micro USB hardwire kit with built-in precise switching power supply module can transform 12V(24V) to 5V. The built-in safeguards protect your devices against overheating.


Safety Notes


  • Pertorm the installation with the ignition in the OFF position.
  • Do not strip any live wires.
  • Correct electnical polarity and grounding is required for safe and proper installation.
  • Only connect to a negative ground DC supply circuit.
  • Not for installation to positive ground circuits.

Technical Details

  • Connector: Micro USB Connector
  • Input Voltage: DC 12V-24V
  • Output Voltage: 5V
  • Output Current: 2A
  • Working Temperature:-40~ 160 Degree F
  • Cable Length: 3.5M
  • Low Voltage Protection: 11.4V for 12V vehicle; 23.5V for 24V vehicle
how to hard wire this kit


5amp add a on fuse
Insert the 2 fuse in the correct position

The supplied 5 Amp fuse MUST be placed in the uppermost socket, as shown above. In line with the red cable. The original fuse is to replaced in to the lower socket. Failure to do so will change the protection of the original circuit within the vehicle. Whilst this will not cause any damae to the vehicle,the lower 5 Amp fuse may above.

Installation Instruction

Installation - Step 1: Connect the supplied "fuse tap cable" to the vehicles fuse box.

Installation - Step 2: Installing the "Car Power Cable".

2.1 Installation of the camera power cable needs careful planning for the cable run and the final position of the camera within the vehicle.

2.2 Starting from the camera end of the cable (with the mini USB) tuck the cable under the vehicle headlining, the "A" post trim and side panel trim until the cable exits towards the footwell.

  • For detals instruction preocess please refer to our user manual in the package.
  • If in any doubt, please ask a vehicle technician prior for help.







DataCaciques