PLEASE NOTE: Decals are Shipped Letter mail From Canada, Please note that shipping out of Canada Can take up to 2-3 Weeks to be delivered, and will be shipped without tracking.

If you have any Questions or Concerns please contact me and I will get back to you ASAP.

1. Never apply Vinyl Decals in a extremely Hot or Cold Surface.

2. Ideal Installation temperatures will be between 60-90 Degrees.

             3. Do not touch the Adhesive Backing of the Vinyl Because there may be oil on your fingers that will prevent the stickers from sticking.

  

            Vinyl Decals will come in 3 Layers

1. The Top Layer will be Transparent, and is called Transfer Paper, This Layer keeps Your decals/Stickers Together until it is installed.

2. The middle layer is Your Custom made Vinyl Decal

3. The bottom Layer is your Backing paper, and is made up of a wax paper, This layer is there to protect the Adhesive that is on your Decal till it is Ready to be Applied.

1. Wipe down area that you wish to install on with 70% isopropyl alcohol and water (50/50 Mix)

2. Line up where you would like to place the sticker with masking tape on each side (with backing paper still attached)

3. Once you have found the spot that you would like to install the sticker onto, break the one side of masking tape while leaving the other side still attached to the surface.

4. Then, lift the sticker as if it's on a hinge, and peel off the backing paper. While holding onto the bottom edge, slowly lower the sticker, using the thumb of your other hand to press from the center out and gradually working your way from top to bottom.

5. Once you have firmly pressed the Vinyl Decal onto the surface using your thumb/squeegee/plastic card you can start to remove the transfer paper by, slowly pulling downwards on a 45 degree angle.

6. Lastly, Enjoy your new Vinyl Decal :)