• 【PACKAGE CONTENT】4 packs clock movements mechanism, 4 sets of mini accessories, 6 sets of clock hands with different styles and lengths. you can also change or make your own clocks with different styles of clock frames according to your needs.

• 🕐【HIGH QUALITY】The clock mechanism kit uses an aluminium needle body, piano baking paint, bright colour, not easy to fade, copper collar, high stability. The pointer is covered with film to prevent scratching. Provide you with a good user experience and decorative effect.

• 🕐【SIZE RANGE】The length of the screw is 18mm / 0.7inch, and the total shaft length is 23mm / 0.9inch. Suitable for 9-13 mm (0.35-0.51 inches) thick clock panel. There is no universal movement, the selection of movement depends on the length of the screw rod on the shaft.

• 🕐【EFFICIENT ACCURATE】Powered by an AA battery (not included), the clock mechanisms has good accuracy, providing accuracy and reliability for the watchmaker. It will not produce an annoying ticking sound and will provide you with a quiet environment.

• 🕐【WIDELY USED】DIY quartz clock mechanism, suit for cross stitch, three dimensional embroidery, craft clock, frameless draw clock, also work well as outdoor clocks for the garden. Many kinds of pointers change the clock stand of various types at any time.

Description

Specification：

Product Name: Clock Mechanisms Battery Powered

Package Content:

4 packs clock movements mechanism

4 sets of mini accessories

6 sets of clock hands

Installation Movement Tutorial：

1. Put the movement in the centre circle of the dial.

2. Install the gasket and nut in turn (the nut should not be too tight).

3. Install the hour hand, minute hand and second hand in turn (the three hands must be parallel).

Installation Precautions：

1. To test whether the movement is normal, please install the battery before installing the movement and test the three-pointers.

2. There is no need to tighten the hexagon nut to fix the movement to avoid the dislocation of the internal parts. Just tighten it gently.

2. The hour hand, minute hand and second hand should be parallel and should not touch each other. The tail of the hand should not touch the clock face, clock frame, glass, etc., to prevent the increase of resistance and slow down of the clock.

Common Problem：

1. The pointer doesn't move. Check whether the battery is charged and whether the positive and negative poles are installed reversely. Be sure to install them correctly according to the positive and negative poles marked on the battery.

2. The pointer goes and stops. Don't insert the second hand too close. Just insert it gently; Do not tighten the hexagon nut under the watch needle too tightly; try to replace the battery.