Each transmitter has an individual ID code. Before starting to use the device, the receiver must be coded with the transmitter.Once the pairing is complete, the ID code is stored in the receiver and does not need to be re-programmed. When you purchase a new X6FG receiver,you must re-pair the code,otherwise the receiver will not work properly.

1.Put the transmitter and receiver together, the distance between them is within 30-50CM.

2.Turn on the transmitter power switch. x6fg receiver will look for the nearest remote control for code matching.

3.Press the(ID SET)switch on the side of the receiver for more than 1 second,the LED light will flash,indicating the start of code matching.

4.When the light stops blinking, the code matching is completed.

Please make sure your servo can be operated according to the transmitter.

Specification:

Channel:6 channels

Modulation mode:GFSK

Spread spectrum mode:FHSS 67-channel pseudo-random frequency hopping

Control distance:400-500m

Remote control voltage range4.8-12v

Remote control operating current:80-120mA

Receiver voltage range:3.3-10V

Receiver operating current:30mA

RF power:<20dbm

Data resolution:4096 levels,0.5us per level

Voltage alarm:7.4v 4.8v

Transmission frequency:2.4GHz ISM band(2400MHz~2483.5MHz)

Support receivers:X6F/X6FG

Package includes

1*X6F receiver

or

1*X6FG receiver

Note: 

X6F receiver does not have gyroscope function.

There is no gyroscope in the factory setting by default,because the gyroscope has a self-test prompt,so the receiver must be kept stationary when power on.This receiver is a two-color light,green light is the general receiver working status indicator,red light is the gyroscope working status indicator,red light is off,no gyro,red light is on,gyro.