Specifications
Model : Automatic tool setting
Color : Black + Silver
Material: Grinding 4S+ superhard alloy
Output mode: Normally close
Normally closed specification technical parameters
Installation instructions
1, the props and the tool setting device must be perpendicular to the contact surface, and vertically contact the contact surface, please install as much as possible on the workbench where the iron filing area is small.
2, please be sure to use the voltage within the rated power supply range, please control the DC10-30V, the current is below 20mA, the ambient temperature range is -25° C-70° C. 3. Please control the cutter tool diameter below 20mm and the cutter speed to be below 50-200mm/min. The tool center should fall to the center of the tool face
When using the blowing function, the air tube has a diameter of 6 mm and an inner diameter of 45 mm. Take care to remove the iron filings and cutting oil attached to the contact surface.
Terms and Conditions
1, the contact can not exceed the stroke of the tool, otherwise the tool and the props will be damaged. (formed as 5.0mm)
2. Please do not release it immediately when touching the tool setting tool by hand to avoid damaging the internal structure of the tool setting tool.
3. When the tool and the tool setting tool are in contact with the tool setting, please do not release it immediately. The tool must be lifted off the contact surface vertically. It cannot be moved laterally. If it moves laterally, it will damage the tool setting tool.
4. When using the blowing function, the air tube has a diameter of 6 mm and an inner diameter of 4-5 mm. Take care to remove the iron filings and cutting oil attached to the contact surface.
Package include: