Feature: 1: This Spectrum Analyzer is Made of fine quality material, with 4.0 inch 480 x 320 large touchscreen display, 100kHz to 5.3GHz widely measure range. 2: The product has a higher anti-static level and a longer service life, and built-in 32Gb micro SD card, can directly record data to the card ,which is convenient for your data sharing and storage. 3: Spectrum analyzer for 0.1-800MHz, with Ultra mode up to 0.1MHz-6GHz. Switchable resolution band pass filters for both ranges between 200Hz to 850kHz. 4: Color display showing 450 scan points covering up to the full low or high frequency range. Faster and more accurate measurement performance, you can easily cope with measurement testes in various fields. 5: When not used as Spectrum Analyzer it can be used as Signal Generator,with sine wave output between 0.1-800MHz or square wave or dual tone output up to 4.4GHz. Built-in calibration signal generator that is used for automatic self test and low input calibration. 6: Connected to a PC via USB it becomes a PC controlled Spectrum Analyzer or Signal Generator. Tinysa-APP transfers data directly to the computer. The USB interface implements CDC protocol and there is a large set of commands that can be invoked over the serial interface. These command can be used to perform measurements or update internal settings. The driver for Windows will install automatically after connecting to a Windows PC. The driver for Linux is built into the kernel. 7: Built-in 3000m-ah rechargeable battery,with type-C charging cable and LED charging indicator,it can be fully charged within 3 hours,no need to charge frequently.
Specifics: Condition: 100% Brand New Display size: 4” TFT LCD (480×320) Max low input frequency: 800MHz, 6GHz in Ultra mode Resolution filters in 1,3,10 steps: from 200Hz to 850kHz Max output frequency: Sinus up to 800MHz, Square wave up to 4.4GHz output level: -104dBm to -16dBm Ultra mode: Level calibrated up to 5.3GHz Internal LNA gain: 20dB up to 4GHz Displayed points per scan: max 450 0-350MHz scan time: 165ms Shortest zero span time: 17ms DANL at 100MHz: -153dBm/Hz (LNA Off) / -169dBm/Hz (LNA On) DANL degrading in ultra mode: 10dB above 2.5GHz, 25dB above 5.3GHz Phase noise at 10kHz offset: -92dBc/Hz Phase noise at 100kHz offset: -110dBc/Hz Input 1dB compression level: +0.5dBm (LNA Off) / -26.5dBm (LNA On) IIP3 without LNA: +18dBm (at least 2MHz apart) / 0dBm (500Hz apart) IIP3 with LNA: -8dBm (at least 2MHz apart) Frequency stability: <1ppm ( -10℃ ~ +55℃) SD card slot: micro SD card Audio out: 3.5mm headphone plug FW update mode activation: Push jog button before switch on Maximum current consumption: 330mA Maximum charging current: 1300mA Battery: Li-polymer 3.7V 3000mAh RF connectors: SMA female Communication Interface: USB-CDC(Type-C),UART-TTL(2.54mm Connector) Appearance Size: 117x72x23mm (Excluding protruding parts)
Note: 1.Please allow 1-3mm difference due to manual measurement. 2.The color might be a little different from the actual product due to color display of different monitors.
Package Included: 1x Host (with 3000mAh battery, 4"display) 1x USB Type-C data cable 2x 30cm ALSR100 SMA cables 1x SMA-SMA barrel connector 1x Antenna with SMA connector 1x Lanyard and touch plectrum 1x 32GB MicroSD card(plugged in the host)