Ten-watt-Tuner plus for Icom 

works with the new out icom ic 7300 an 7200 as well as the ic 7100 Dstar

IC-7600 IC-7610 IC-7700 IC-7800 IC-7810

Activate the 'tune' feature in your Icom
by MCR COMMUNICATIONS

ALSO HAS VOLTAGE LIMITER SELF BLEADING CAP AND ISOLATION BUILT IN TO PROTECT YOUR RADIO

The new unit works with Icom radio’s having an antenna tuner jack on the rear of the radio 4 pin Molex type . 

The device simply plugs into the tuner jack and your radio will think there's an Icom antenna tuner attached.

This activates the 'tuner' button on the front panel of the 706 series (works with others like the (new7100) 7200 (new 7300)( NEW 7610 )706 718 726 737 746, 756, PRO, PRO II, etc.).

When the tune button is operated, the radio will transmit a 10 watt CW signal for approximately 8-10 seconds.

This low power signal minimizes risk and damage to your finals while you check match SWR or tune the antenna with your own external tuner. 

This is very handy for tuning your valve amp and high power tuner at very low power levels to prevent any damage to you radio .

The adapter/interface is small and compact.

This is a first class product, using a properly fit thick high quality vinyl boot (no cheap heat shrink tubing).

High temperature adhesive is used to seal the components, sealing out moisture and retaining the boot.

This boot does not slip off. There is no PC board, or big silly  box hanging off the back of your radio.

This is ideal for mobile and portable use as it's about the same size as the connector itself.

The passive network used here is a long lasting streamline solution for your application.

Complete with application note.

Your ICOM radio has a low power TUNE feature,
Activate it today!

for more radio gear Check out my other items

why not check out my eBay shop