You are viewing the auction for a set of 3D printed replacement parts for the GI Joe Cobra Water Moccasin vehicle.  This auction is for the parts lot you see in the photos, and nothing more.  These parts are being sold as new, and have NOT been installed on any vehicle.  These parts will fit either the original 1984 Water Moccasin, or 1988 Tigerforce Tiger Shark vehicles in 1/18th or 3.75" (inch) action figure scale.  These parts were printed by Shapeways in PA12 SLS versatile plastic.  Please reference the photos for the finish & texture.  The link bar, for the steering vanes, has had nylon bushings installed.  The pivot nubs of the vanes will press fit, and snap into the link bar.  Please note the direction of installation.  USPS Priority Mail or Ground Advantage shipping within the ConUS only!  Please note, should you be the winning bidder on more than one of my auctions, PLEASE WAIT for a revised invoice with combined shipping.  Questions are always welcome, and thanks for looking!