To Assemble and lnstall:
1.Unpack the unit completely and confirm that parts are present,SEEFIGURES 1-3 above
2.Connect the repeller head,pole sections,connecting part and groundstake.SEE FIGURE1-3 above.
3.Turn power switch to “ON” position .SEE FIGURE2.
4.The PIR repeller is designed to be left ON continuously. It uses four2/3AA size NI-MH rechargeable batteries
5.Once turned ON,the red-LED light and ultrasonic signal will activate for 15seconds.Among the time ,there is sound waves for 2.5 seconds at the beginning.At the same time ,the white-LED lights flash blasting. Following this activation,the unit will move to stand-by mode.
6.The unit is now ready for installation.The location should allow adequate sunlightTo keep the batteries fully charged.Be sure that the area needing protection iswithin the effective range of the repeller SEE FIGURE2.
7.For best results,keep the repeller head roughly9-10 inches above ground.
8.Take acre not to stress or break the repeller when installing in hardground.It is a good idea to prepare the ground for the ground stake toavoid damage to the unit.
9.When the PIR sensor detects motion,red-LED light will be lit up,The ultrasonic signal and the white-LED lights will run for 15 seconds .Following this,the Repeller will return to stand-by mode
10.When the device is working and the PIR sensor detects motion,theDevice will run for other 15 seconds in the next time.
Description:
This Repeller repels all animal and pest through emitting a mixture of ultrasonic, sonic and powerful flashing LED strobe lights, driving the animals away. With a solar panel on the of the device to recharge batteries(including 3 x AA batteries). Device will begin to work whenever a slow moving object is detected and will return to hibernation mode in normal times. It can be left out in any weather conditions. Perfect to protect your farm, garden, yard, lawn, patio, garage from unwanted animals and pests. The bar can be inserted in the earth.
Features
- Color: Green.
- Material: ABS.
- Size: 14.5 x 9.5 x 36.5cm (LxWxH).
- The safe/humane way to keep cats and other unwanted pests (Dogs, Foxes, Squirrels, Rodents, some insects) out of your garden with fully adjustable sensitivity and frequency
- Infrared PIR motion sensor detects the movement and body heat (reducing fake activation, extending battery life) upto 7m away activating the cat repeller to a high frequency sound, irritating to the cat and almost inaudible to humans
- Easy set up - Includes zinc coated ground stake and tab for fitting directly to wall or fence. The bar can be inserted in the earth.
- This cat repellent is fully weatherproof, you may leave outside in all weathers.
- Device will begin to work whenever a slow moving object is detected and will return to hibernation mode in normal times, saving energy.
- Sound wave range is above human hearing range, which will not bring any noise pollution.
Specifications
Battery Voltage: 4.8V.
Power Supply: Solar panel/ 3 x AA rechargeable batteries(Built in).
Frequency: 16-60Khz.
Waterproof: IPX4.
Effective Range: About 8 meters.
Detection Angle: 110 degrees horizontal。
Working Method: Ultrasonic wave and strong flashing LED.
Item included:
1 x Ultrasonic Outdoor Solar Animal Deterrent with Motion Sensor Flashing LED Light Waterproof Animal Scarer Repellent (Green)
WARNING! Always check for underground utilities,cables orwires before digging or installing ! Failure to check could result inpersonal injury,property damage or even death.