SPARE
8mm/16mm
Projector Lamp Connector
Will Fit The Following Double Pin Type Lamps (pin gap 6mm)
12volt/100watt Reflector Lamp (A1/231) Majority of 8mm
Projectors
12volt/100watt Capsule Lamp (M250 GX5.3) Eumig Mark S & others
15volt/150watt Reflector Lamp (A1/232) Elmo ST1200, Sankyo 800 Stereo & others
24volt/250watt Capsule Lamp (A1/223) Rank Aldis 16mm & others
24volt/200watt Reflector Lamp (A1/252) Earlier Elf 16mm Projectors
24volt/250watt Reflector Lamp (A1/259) Elf and Some Bell & Howell 16mm
Projectors
May also be used if you are wanting to convert
an old
projector to a modern lamp type.
Does your projector lamp flicker on and off occasionally?
Or perhaps you've fitted a new lamp that still
refuses to light?
Usually this is down to corroded contacts within
the original
lampholder caused by high current (8 amps for a 12v
100w lamp
and around 10.5 amps for a 24v 250w lamp).
This in turn will shorten the life of a new lamp
significantly, which
is definately not cost effective. These new
porcelain holders
have a better sprung contact system inside that permits
a more stable current transfer to the lamp. The cables
are protected by heat resistant rubber and as a final
protection, encased in a further heat/flame
retardant shroud.
This item needs to be soldered to
the original
wiring of your existing lamp.
Strictly no
foreign cheques, money orders, foreign cash
or direct bank transfers.
Only Paypal from overseas
buyers.
TERMS
(You are agreeing to the following when purchasing this item)
Please note that
I do NOT send out goods on a Wednesday.
My postage days are Monday, Tuesday, Thursday and Friday.
I do not ship to countries that are covered by my excusion policy.
An unpaid item
dispute WILL be opened after 5 days if payment not received
This can be extended providing buyer responds to
invoice/reminders for payment.