Car Audio Stereo Installation kit for installing a new after market headunit into your Citroen. This kit includes Wiring Harness Adaptor, Aerial Adaptor and Stereo Removal Keys.  

Package Includes:

• Wiring Harness Adaptor
• Aerial Adaptor
• Stereo Removal Keys

This kit allows fitment in the following vehicle:

Car Make / Model	Year	Remarks
Citroen Berlingo	2008 - 2018	Vehicles With Single FAKRA Antenna Connector Connection: Quadlock (Fakra)
Citroen C2	2005  - 2009
Citroen C3	2005 - 2016
Citroen C3-Picasso	2009 - 2017
Citroen C4	2004 - 2018
Citroen C4-Picasso	2009 - 2018
Citroen C5	2005 - 2017
Citroen C6	2005 - 2012
Citroen C8	2005 - 2014
Citroen DS3	2009 - 2016
Citroen DS4	2011 - 2016
Citroen DS5	2011 - 2018

Note: Some Models may require fascia panel Adaptor

WIRING HARNESS: The wiring harness will allow to install the stereo without having to cut any wires.

This adapter is required when replacing your factory fitted radio with an aftermarket radio. It will convert the original vehicle power & speaker wiring connectors to a standard ISO connector. Simply plug one end of the adapter into your cars wiring harness and the other into your new radio. *For Aftermarket Radio With DIN Antenna Connector*

AERIAL ADAPTORS: An Aerial Adaptor is needed when replacing the original factory fitted head unit with an aftermarket head unit.

Please Note: Blue wire needs to be connected to the Remote Antenna or ignition supply wire (if rem ant wire not available) on back of car stereo.

STEREO REMOVAL KEYS: Stereo Removal Keys to remove headunit from the fascia cage. Many OEM manufacturers are incorporating special locking mechanisms into their head units in an attempt to prevent stereo theft. This means that to remove one of these units you will require a manufacturer specific stereo removal key to prevent damage to the head unit or the surrounding fascia and cage.

Please Note:

• When connected your new stereo may not power up, and this is no fault of the wiring harness purchased.
• Audi / VW / Skoda / Fiat and other vehicles tend not to have an ignition switched live feed.
• In these cases it is necessary to manually connect a spurred live feed from fuse box for example to feed switched power so the new stereo turns on and off with the key.
• The wire in particular on the new wiring harness will be the red wire.

IMPORTANT NOTE: Please make sure that is the correct Fitting Kit for your car by firstly checking to see if your make, model and year of car is listed in the advert. Secondly by checking to see if the connection in the picture listed is the same as you have in your vehicle.

FKIT-CITROEN-11