68 Pin Active - Female Connector
For use in SE (Single Ended) mode operation (not LVD mode).
Just plug this terminator into your ribbon cable.
Setting The Jumpers On Your Drives
Each of your drives needs a unique ID number from 0 through 15. Set the jumpers on your drives as shown in the table.
Note that 0 is usually for your boot drive and 7 is usually reserved for your controller.
BIT 3 | BIT 2 | BIT 1 | BIT 0 | ID |
OFF | OFF | OFF | OFF | 0 |
OFF | OFF | OFF | ON | 1 |
OFF | OFF | ON | OFF | 2 |
OFF | OFF | ON | ON | 3 |
OFF | ON | OFF | OFF | 4 |
OFF | ON | OFF | ON | 5 |
OFF | ON | ON | OFF | 6 |
OFF | ON | ON | ON | 7 |
ON | OFF | OFF | OFF | 8 |
ON | OFF | OFF | ON | 9 |
ON | OFF | ON | OFF | 10 |
ON | OFF | ON | ON | 11 |
ON | ON | OFF | OFF | 12 |
ON | ON | OFF | ON | 13 |
ON | ON | ON | OFF | 14 |
ON | ON | ON | ON | 15 |