This will fit some 1/10 models. Please check measurements below before ordering as this will not fit all.
Simply replaces the normal 12mm hubs with these extensions. Great if intending to put larger wider wheels on or if simply needing to push the wheels away from the chassis.
How to check if this will fit?
1) Simply check all 4 wheels use a 12mm hub already.
2) The axle is 4mm in diameter
3) A 4mm nut was originally used to secure the wheel in place (this will no longer be needed).
4) The hole in the axle is 2mm (if no hole these wont be suitable). The hole should be on the smooth section of axle before the threaded section.
How to install?
These slot onto a 4mm axle and then are secured in place by a 2mm pin (included). A rubber ring is then placed over the pin to keep it in position. Slot the wheel onto the 12mm hex hub on the end and then install the included washer and screw. Done!
Whats in the pack and measurements?
4 x 12mm extension hubs:
- 24.22mm long extension (measured end to end)
- 4mm center hole for a 4mm diameter axle (pin end)
- 4mm threaded end (hub)
4 x 2mm x 10mm pins
4 x rubber o-rings
4 x M4 screws
4 x Washers
Note: These are not suitable for 2WD models. These will not replace bearings. For these to fit your model must already use 12mm hubs and have a 2mm hole in a 4mm diameter axle.
Part Number: N10133
Made by: BSP
Material: Alloy
Colour: Green